I have a truck that won’t run and is not getting gas to the engine. Fuel pump is running, have a new filter and new fuel pressure
I have a 1989 Dodge pickup with throttle body injection. I can hear my fuel pump running but the truck will not start. If I pull the fuel line off of the throttle body I get fuel, if I remove the injectors there is no fuel. The throttle body has been cleaned, fuel pressure regulator was replaced, inline fuel filter was replaced, as was the screen on the fuel pump. If I pour a little gas into the throttle body the truck starts with no problems, but dies once that little bit of gas is burned up
My car has an automatic transmission.
My car has an automatic transmission.
Experienced mechanics share their insights in answering this question :
Hi There,
It sounds like you may have a clogged fuel injector or potentially a faulty injector that is fried internally. I would suggest testing them if you have access to a multi meter. Disconnect the injector from the electrical connector and set your multi meter to Ohms mode and measure the resistance of the injector. After testing all injectors, compare the resistance. They should be the same or very close. If they are not, they will likely need to be replaced.
It sounds like you may have a clogged fuel injector or potentially a faulty injector that is fried internally. I would suggest testing them if you have access to a multi meter. Disconnect the injector from the electrical connector and set your multi meter to Ohms mode and measure the resistance of the injector. After testing all injectors, compare the resistance. They should be the same or very close. If they are not, they will likely need to be replaced.
How to Identify and Fix Common car Problems ?
Our sources include academic articles, blog posts, and personal essays from experienced mechanics :
The most common cause of fuel pump failure is frequently running the tank low on fuel, which causes the motor to overheat. The second most common cause is fuel contamination, usually dirt and rust particles that clog the fuel strainer and prevent the pump from drawing enough fuel under high engine load.
A damaged fuel pump might make a loud, whining sound that you`ll hear from your gas tank. The pump may also make this noise if you`re low on fuel or the fuel in your tank is contaminated. The normal noise your pump makes is a low hum. Loud whining indicates there is a problem.
If your car doesn`t start with a new fuel pump, chances are the fuel pump is either not hooked up right or is broken. Double check that the pump is correctly installed and all hose attachments are plugged in. Next, check for any blockages along the fuel line—this can also cause your car not to start.
If the fuel pump relay has an issue while the vehicle is operating it will cut off power to the fuel pump, which will cause the engine to stall. A faulty relay may allow the vehicle to be restarted a short while later, while a completely failed relay will not.
To confirm that your pump has failed, check the pressure in your fuel lines with a fuel pressure gauge; if it reads zero, then your pump is likely dead. You can also check your car`s fuse box; a blown fuel pump fuse is another reliable symptom of a failed pump.
If fuel pressure is too high, your vehicle`s engine could be over fueled, leading to many of the symptoms listed below. Some of these symptoms include your engine running rough, poor fuel economy and black smoke from the exhaust.
Just because you hear the fuel pump run does not mean it is pumping the correct pressure to the injection system. If the pressure is real low or the filter is plugged solid, then the pump may not get enough fuel to the fuel rail. The only way to know is to test the fuel pressure at the fuel rail test port.
If a fuel pump isn`t installed correctly, it either won`t work at all or won`t supply enough fuel to the engine. When the fuel pump isn`t working right, your engine isn`t getting the amount of fuel it needs to run well. Your engine loses power and fuel efficiency.
Step 1: Turn the key to run position. Locate the reset button to the fuel pump shut off switch. Press and hold the reset button for about 20 seconds. Note: The fuel pump shut off switch reset button is usually located either under the dash in the driver compartment or under the driver or passenger seat.
Relevant Questions and Answers :
the most relevant questions and answers related to your specific issue
I have a truck that won’t run and is not getting gas to the engine. Fuel pump is running, have a new filter and new fuel pressure
ANSWER : Hi There,
It sounds like you may have a clogged fuel injector or potentially a faulty injector that is fried internally. I would suggest testing them if you have access to a multi meter. Disconnect the injector from the electrical connector and set your multi meter to Ohms mode and measure the resistance of the injector. After testing all injectors, compare the resistance. They should be the same or very close. If they are not, they will likely need to be replaced.
It sounds like you may have a clogged fuel injector or potentially a faulty injector that is fried internally. I would suggest testing them if you have access to a multi meter. Disconnect the injector from the electrical connector and set your multi meter to Ohms mode and measure the resistance of the injector. After testing all injectors, compare the resistance. They should be the same or very close. If they are not, they will likely need to be replaced.
I installed a new fuel pump on a 1997 dodge caravan, it turns on but no gas is getting to the engine. Access to the fuel filter is
ANSWER : Hi there. It sounds like the fuel filter being corroded is the issue. It will need to be removed as well as any lines that may be corroded. You may have to replace a good portion of the lines if there is a lot of corrosion. If the vehicle cannot be serviced where it is then fuel lines can be used but they need to be able to handle over 50 psi. You would be best to get some assistance from a certified mechanic, like one from YourMechanic, that can come to you to [replace the fuel filter and lines] https://www.yourmechanic.com/services/fuel-filter-replacement
Not getting enough fuel car will not run right. It stalls when you give it gas and stalls when it’s running. It’s a 1984 Ford Escort.
ANSWER : Hi there, thanks for writing in. Several early 80’s Ford’s swapped from carburetor to fuel injected engines; including your ’84 Ford Escort. However, there were two different fuel systems available that year. If your Escort has the fuel injected engine, one item I’d check is the EGR valve or clean the throttle body.
Both systems impact fuel delivery into the engine and if they are dirty or clogged with excessive carbon build up, can starve the engine to create this type of issue. If it’s the carburetor version, the carburetor might need to be rebuilt, or may be an issue with float bowls inside the carb.
If you need assistance diagnosing the exact issue, feel free to contact one of our professional mechanics to complete an engine is stalling inspection firsthand at your own location.
Just replaced my fuel pump but its not getting any power tested fuel pump relay and fuel fuse both good tested the wires all good.
ANSWER : You need to look at the theft light on dash to make sure it comes on and goes off when you turn the key to the on position. If light comes on and stays on then your theft system is causing the fuel pump to not be engaged. I recommend you check the theft system and then scan the computer for theft system codes. You may need to reprogram the keys to work or you have an bad sensor for the ignition key in the steering column.
Replaced fuel pump. Car won’t start. 2002 Infinity I35
ANSWER : Hi there – the metal component you describe is a fuel check valve on the fuel return line. Its function is to maintain a small amount of pressure in the fuel system so that starting does not require the fuel pump to run very long before the engine will start. Having replaced the fuel pump and fuel filter, I would check fuel pressure while the car is running. This is to check the fuel pump relay for burned contacts that won’t support full electrical current to the pump, and for proper fuel pressure – a malfunctioning fuel pressure regulator could also restrict power and higher speeds if pressure is too low. I would recommend an inspection of the fuel system by a mobile, professional mechanic, such as one from YourMechanic, who will come to your location, diagnose this problem, give you an accurate assessment of damage and cost estimate for repairs.
Odometer has lines, won’t start unless I put fuel in the intake. The fuel pump keeps running and doesn’t shut off? Seems like the truck wants to start.
ANSWER : Hi there. From the description you have provided, you’ve replaced the fuel pressure regulator, the fuel pump never shuts off and puts fuel in the throttle body, it runs until the fuel is gone, and the odometer has lines instead of mileage. This would appear to be a fuel control problem and communication failure.
Some possibilities are that the PCM (Powertrain Control Module) has shorted internally causing the fuel pump relay to be commanded continuously on, injector driver circuits are inoperative, or failed communication to the IPC (Instrument Panel Cluster).
This all needs to be confirmed through diagnostic procedures. I recommend having your vehicle’s fuel pump never shuts off, truck won’t start condition be diagnosed and repaired by a certified technician, such as one from YourMechanic.
Installed new delphi fuel pump and fram fuel filter. still no pressure on fuel rail valve and wont start. 2003 Chevrolet Tahoe
ANSWER : Hi there – I suspect you have weak power getting to the fuel pump. I would first check the voltage coming out of the fuel pump relay. If the contacts in the relay are burned, you will not get reliable current flow to the pump. Check the fuel pump ground as well (voltage drop across the ground, not just continuity). I recommend a fuel system inspection performed by a mobile, professional mechanic, such as one from YourMechanic, who will come to your location, diagnose this problem, give you an accurate assessment of damage and cost estimate for repairs.
I changed fuel pump and truck ran great for 3 days. Now after 3 days truck dies. It will start runs few min then dies like before
ANSWER : Check the bottom of the fuel tank for sediment. Age and mileage could have accumulated a lot of it at the bottom of the tank. If you did not, check and change the fuel filter. Rule of thumb – replace the fuel filter any time you replace a fuel pump. Also, check the wiring for any chaffing on the fuel pump when you remove it. While your problem is kind of unique, I have seen many GM truck fuel tank baffle loosen over time, occasionally rubbing against the fuel pump can intermittently short it out and/or block the fuel pump pick up. To have this diagnosed, consider having a certified expert from YourMechanic inspect the stalling issue to have this corrected.
