How do I set the seat belts in automatic locking mode?

ANSWER : Automatic locking mode is a feature that keeps the seat belts from having any slack. This feature should always be used when attaching a child restraint system. To set the system, follow these steps:
1. Buckle the seat belt.
2. Pull the shoulder strap downward until the entire belt is extracted from the retractor. If the belt is an inflatable belt, then instead of this step, pull the lap belt upward until the entire belt is extracted.
3. Release the belt and allow it to retract.
4. Try and move the belt to make sure that it is locked.

ANSWER : While the passenger front and rear seat belts can be used in Vehicle Sensitive mode, they can also be used in Automatic Locking mode. This provides you with better security for child car seats and booster seats, and can be used in other situations as well. Here’s how to activate it:

Make sure the belt is buckled properly.
Pull the shoulder belt completely out of the retractor.
Let the belt retract. You should hear a click while it does this. Test the shoulder belt to make sure it’s locked.

To disengage Automatic Locking mode, just unlatch the belt and let it slide all the way back into the retractor.

Tip

If the seat belt won’t enter Automatic Locking mode, you should have it replaced.

ANSWER : Your seat belts can be set to vehicle sensitive mode, which allows the shoulder belt to extend and retract as you need it. It will automatically lock when the system detects sudden deceleration while you’re traveling at over 5 MPH. However, you can also set your seat belts (the passenger front and all rear seat belts) to automatic locking mode. Here’s how to do that:

Connect the buckle and the seat belt tongue.
Pull the shoulder belt down until it is completely extended from the retractor.
Let the belt retract. It should make a clicking sound. If you don’t hear it clicking, automatic locking mode is not engaged.

To deactivate automatic locking mode, just release the buckle and let the seat belt retract.

Tip

Automatic locking mode must be engaged again every time you unbuckle the seat belt.

ANSWER : Hello. The smaller belt is known as your timing belt, and it works inside the engine to keep mechanical components aligned with each other during the compression cycle. The serpentine belt, which is the big belt, drives the alternator, water pump, AC compressor, and a couple of other components. If the small belt broke it is likely the timing belt. This will cause the car to stall, lights to illuminate, and can even cause serious damage to the engine. Typically replacing a timing belt is a lot more complicated and expensive than replacing a serpentine belt. You may want to receive a second opinion on the car before you go ahead with repairs.

ANSWER : The solenoid is on the door latch and is most likely the cause of the problem for your 2005 Toyota Tacoma. If you want to have this inspected and repaired, a certified technician from YourMechanic can come to your home or office to diagnose your door lock and perform the correct replacement.

ANSWER : Hi there. When the locks look as if they are trying to move but do not, it’s typically due to a fault with the primary module or relay that powers the door locks. There are many different components that make up the power lock system, so before you attempt to remove or replace the module, you might want to have a professional mobile mechanic complete a power door locks are not working inspection.

ANSWER : You will need to have your body computer scanned to get the codes from the seat belt module. If may have stored the code due to the battery was not disconnected when seat was removed causing the system to see problems in seat circuits. You may just have to have the codes cleared and if no problem codes return the you will be okay.

ANSWER : Since this is a new vehicle, if you are having any issues with safety equipment like the seat belts and/or tensioners, your best bet is to take the vehicle to the Toyota dealership service department to have any issues addressed and/or repaired. The warranty should cover any issues that may be occurring at no charge to you.