How do I buckle the center seat belt in the second row of seats?

ANSWER : While the driver and passenger sides (front and rear) have conventional shoulder and lap belt combination systems, the center seat belt in the second row seat is a little different. It’s a three-point system that uses a separate lap and shoulder belt. There are also two buckles that must be used at the same time. Here’s how to use it:

Sit as far back in the seat as possible.
Pull the lap belt over and buckle it.
Pull the shoulder belt across and buckle it in the other buckle.
Double check that both buckles are secure.

Tip

Never use just the shoulder belt or just the lap belt. Both must be used at all times in the center position in the second row.

ANSWER : Hello, thank you for writing in. There are several different recalls for your make and model that revolve around the seat belts. The easiest way to look them up for your exact vehicle is online using your VIN. Most of them pertain to the seat’s sensor which turns on the airbag, and not a shredding issue. You will want to verify this however through the US Department of Transportation to make sure you address any recalls pertaining to your vehicle. While there have not been many reports, you will want to make sure any protective plastic or rubber pieces that cover that section of the belt are still in place. If you need help replacing the belts, if not covered by the manufacturer, contact our service department to schedule an appointment.

ANSWER : The second row center seat’s shoulder belt should stay connected at all times unless you need to fold the seat down or accommodate cargo. Of course, when those situations arise, you will need to know how to release it. Here’s what you need to do:

Use the tab from the lap belt into the back slot on the buckle.
Use the vehicle key to release the belt (the mechanical key or the mechanical key

insert with the smart key system).

Let the belt retract.
Stow it away safely.

Tip

Always stow the belt in the ceiling retractor pocket and latch it securely.

ANSWER : Hi there. The same mounting areas are there on both vans. The carpet is different so it will not look right with the captains chairs unless you replace the carpet, too. Other than that, as long as you get the captains chairs complete with the mounting hardware, you can easily switch them out. If you need to have someone do this for you, consider YourMechanic, as a certified mechanic can come to your car’s location to do this.

ANSWER : You will need to have your body computer scanned to get the codes from the seat belt module. If may have stored the code due to the battery was not disconnected when seat was removed causing the system to see problems in seat circuits. You may just have to have the codes cleared and if no problem codes return the you will be okay.

ANSWER : Hello. The smaller belt is known as your timing belt, and it works inside the engine to keep mechanical components aligned with each other during the compression cycle. The serpentine belt, which is the big belt, drives the alternator, water pump, AC compressor, and a couple of other components. If the small belt broke it is likely the timing belt. This will cause the car to stall, lights to illuminate, and can even cause serious damage to the engine. Typically replacing a timing belt is a lot more complicated and expensive than replacing a serpentine belt. You may want to receive a second opinion on the car before you go ahead with repairs.

ANSWER : If your shoulder belts in the second or third row seats aren’t in use and you want them out of the way, there’s a convenient solution close at hand. The following method can be used for both the second and third row belts:

Grasp the shoulder belt.
Run the belt through the hanger (the hanger is located on the side wall and there are two for each seating position, one on each wall).
Secure the seat belt plates.
Remove the belt from the hanger when passengers need to use them.

Tip

Never store away the belts if you have passengers (everyone needs to buckle up).

ANSWER : You may have open recalls for the seat belts on your vehicle. I would call the local dealer to verify open recalls for the seat belts and repair for them may be free of charge. The seat being broken is most likely not repairable and need to replace the seat.