Car won’t drive after over heating on the highway

ANSWER : Hi there. Most of the time when you overheat this engine it will also cause the transmission to get too hot. When this occurs it can easily cause transmission failure. I would suspect this if the vehicle does not move at all. If it move but is severely lacking power then you either have some serious internal engine damage or a failure in the catalytic converter from the overheating. It sounds like it is the transmission though. I would recommend having a transmission specialist take a look at it.

ANSWER : Common causes of no cabin heat include malfunctioning blend door(s) (part of the in-dash ventilation network), a faulty or stuck heater control valve, a plugged heater core, stuck open engine cooling thermostat, collapsed hoses, and low coolant level. The cost to resolve the problem depends on which of the foregoing faults is the cause. If you desire a diagnostic to determine exactly why there is no cabin heat, please request a non functioning cabin heater diagnostic and the responding mechanic will come right to your location and get this resolved for you promptly.

With regard to your air conditioning system, if merely re-charging the system restored normal operation but the a/c ceased to function after a month or so, that scenario typically suggests a leak. Some leaks are really cheap to repair, like if a couple o-rings need to be replaced in system piping but if the leak is at the compressor shaft seal, that repair is more costly. It is not expensive to find the leak and diagnose the system and once the leak is found the mechanic can let you know of the exact cost to repair the leak and re-charge the system. If you desire that service please request an a/c system diagnostic – suspected refrigerant leak and the responding certified mechanic will get this taken care of for you. If you have further questions or concerns, do not hesitate to re-contact YourMechanic as we are always here to help you

ANSWER : Hi there. What you are describing is common with a CVT malfunction. This unique to Nissan transmission has experienced some hit and miss issues as you’ve described and can cause the type of warning lights and symptoms you’ve described. However, it is also possible that the CVT recall problem is not the root source of the other error lights. Specifically, the TPMS and ABS warning lights could be caused by an actual sensor failure; which may have triggered the CVT problem in the first place. As difficult as it is to wait without knowing facts, the best advice we can offer is to wait for the dealership to contact you about their diagnosis. Hopefully the factory recall is the source of your other issues and the repairs will resolve this problem.

ANSWER : The initial failure was likely caused by a sudden fuel system (e.g., failed fuel pump) or electrical (including ignition) faiure. Prior to performing diagnostics be sure you have a fully charged battery that passes a load test. Then, confirm that the engine immobilizer system (security system) is not activated thus preventing the car from starting. If the starter motor is not functioning, check for power to the starter motor when the key is held in the "start" position. If there a large voltage drop at the starter motor or no power at all, you may have a faulty ignition switch but you do have to check out the entire starter circuit, which includes grounds, wiring (some of which is very heavy cabling), fuses, relays, the ignition switch and terminations. On the other hand, if the starter motor is getting power but the starter doesn’t work, then the starter is condemned and replaced. If you desire that a certified mechanic resolve this, please simply request a no start diagnostic and the responding certified mechanic will get the problem diagnosed and repaired for you. Please let us know if you have further concerns or questions as we are always here to help you.

ANSWER : Hey there. This sounds like a transmission problem. You should first check the transmission fluid to make sure it is full and does not have a burnt smell. If it is burnt, then your transmission clutches are bad, and it would need an overhaul or replacement transmission. If you would like to have this checked out by an expert, a certified technician from YourMechanic can inspect the revving issue in person and advise you on the appropriate next steps.

ANSWER : This is a sign of a faulty transmission control solenoid. Modern automatic transmissions use pressurized hydraulic fluid to change gears. Every time a gear change is required, the car’s computer activates a transmission solenoid, which directs transmission fluid into the valve body to engage the correct gear. When this is faulty or not working properly, this can cause a delay in gear shifting or in some cases cause the car to not shift at all. If you’d like, a certified technician from YourMechanic can come to your home or office to inspect your vehicle, and provide a definitive diagnosis for the shifting issue.

ANSWER : Hello there. The charging system on the car may not be charging the battery as you drive and the systems that keep the engine running are priority so the engine will stay running until the voltage drops below about 9 volts but the lighting and some other accessories may cut off above this voltage first. You should have the charging system tested to see if the alternator needs to be replaced.

ANSWER : There are reports that the replacement alternators will not communicate with the engine computer and will not charge correctly. I recommend using only the manufacturer approved replacement part. It can be new or remanufactured but approved for use in the vehicle. Some lower cost alternators on the aftermarket will have charging problems since they will not communicate with the ECM on the vehicle and will stop charging.