Under hard acceleration or braking, a rubbing sound occurs

ANSWER : I would suggest trying to disconnect and reconnect the wiring to the rear lights. I have seen these older Toyota vehicles rear lighting short out on the lights themselves due to the way the light circuit was made on the lamp housing. Look at the housing circuit on the light to see if one is touching another, and that could tell you why it is malfunctioning. There could also be a problem with the brake light switch. If you are not comfortable dealing with wires, I recommend getting in touch with a certified mechanic who can look at your brake light issue for you to see what’s going on.

ANSWER : The brake pedal is working to stop the vehicle, but there may be air in the controller unit causing the ABS brakes to not function. I recommend bleeding the brake system from the farthest location from the master cylinder to the master cylinder including the ABS unit. If the brakes are still spongy after a full bleed, then the controller will need to be replaced. If you need further assistance with your brake pedal being spongy, then seek out a professional, such as one from Your Mechanic, to help you.

ANSWER : Hi there. The first thing that pops in my mind beyond of what you have listed is perhaps the electrical harness attached to the brake switch. Perhaps the harness itself is damaged or you have an exposed wire, loose ground wire somewhere. You might want to have a professional mobile mechanic come to your location and complete a brake lights not working inspection to help you diagnose this issue.

ANSWER : There are quite a few possibilities and it will just require a careful examination. I would recommend that you have your vehicle’s suspension inspected by a certified Mechanic to determine the location of the interference. The service to request is a suspension inspection and the responding certified Mechanic will get your concerns addressed. If you have further questions, do not hesitate to re-contact YourMechanic as we are always here to help you.

ANSWER : Hi, thanks for writing in. You need to check the brake switch install adjustment. You may have the switch adjusted too tight and it is holding the the brake pedal partly down. This will cause the brake master cylinder to not release the brakes when you let off the pedal. Readjust the switch away from the pedal until you feel some free play again in the pedal. This should fix the problem. If you would like help, consider having an expert automotive technician from YourMechanic come to your home or office to inspect and diagnose this issue for you, and make or suggest any repairs as needed.

ANSWER : Hi. I will help you with this issue you are having with your 2001 Durango. Unless you bled the master cylinder, it is possible there is still air in the system. If you car is equipped with ABS, air could have also gotten trapped in the ABS modulator. If ABS equipped, a bi-directional scan tool would be essential to manually activate the ABS system to clear air from that segment of the lines while you are bleeding the system. It is also possible that in all of this work somehow the proportioning valve has been affected causing the desired pressure differential, front versus back, to get out of spec. Using a 2,500 PSI gauge, you can check the pressures at each wheel and that will definitely give you a clue as to which brake circuit is the issue (or both), whether the proportioning valve is working properly and whether the line pressures at each wheel are within spec. Should you need a second opinion, by all means feel free to contact YourMechanic for assistance and we will diagnose and repair the issue for you.

ANSWER : It’s possible to have someone alter the brake pedal or adapt a brake pedal from a different vehicle. You may call around to some customization shops to see if anyone is interested in taking on the project. But first, I would try reaching out to the selling dealer with your concern – especially since it is a new model. Good luck.

ANSWER : Hi there – your brake light switch needs a minor adjustment. It is adjusted too "tight" or close to the brake pedal lever, or possibly has failed. Adjusting/replacing it will eliminate this flickering problem. I recommend a brake light isn’t working inspection performed by a mobile, professional mechanic, such as one from YourMechanic, who will come to your location, diagnose this problem, and give you an accurate assessment of damage and cost estimate for repairs.