Car revs high and jerks when first starting to drive car, while driving.

ANSWER : Hi There,
It sounds like you may have low transmission fluid or a faulty transmission control solenoid. As you know, automatic transmissions use pressurized hydraulic fluid to change gears. Every time a gear change is required, the car’s computer activates a transmission solenoid, which directs transmission fluid into the valve body to engage the correct gear. When this is faulty or not working properly, this can cause a delay in gear shifting or in some cases cause the car to not shift at all. This type of problem is amplified any time the transmission is low on fluid creating a drop in hydraulic pressure. I would recommend having a professional from YourMechanic come to your location to diagnose and inspect your vehicle.

ANSWER : The issue you are having is probably due to an intermittent fault in the starter motor itself or a deficiency in the starter electrical circuit, for example a large voltage drop due to a poor ground or a high resistance connection. These issues can be readily diagnosed and resolved on a mobile basis if you request a hard starting diagnostic. If you request that diagnostic, the responding certified mechanic will get this resolved for you promptly. Based on Toyota’s Factory Service Manual, the battery should not be disconnected if the vehicle engine is running. The battery acts as a large resistive voltage sink and consequently taking the battery out of the circuit, while the alternator is still running, can create a voltage spike on the car’s electrical system which is not good for voltage sensitive components such as the engine computer. If you have further questions or concerns, do not hesitate to re-contact YourMechanic as we are always here to help you.

ANSWER : Hey there. This may also be caused by what is called the fuel pressure regulator. This is a unit that helps to maintain the fuel pressure at the proper level. When this is not working properly, the fuel pump may be pumping properly, but the fuel may not arrive at the fuel injectors at the proper psi. When this happens, this can cause a lean fuel condition which may cause the car to hesitate, misfire, or stall. If you would like to have an expert pinpoint the issue, a certified professional from YourMechanic can come to your car’s location to inspect the hard start problem and confirm which repairs are needed.

ANSWER : Hi There,
What you are describing may be a result of a faulty speed sensor, potentially low transmission fluid or a even a faulty transmission control solenoid. As your vehicle travels down the road, the computer analyzes data being sent by vehicle speed sensors and engine speed sensors. Based on this information, the Engine Control Unit (ECU), or the Transmission Control Unit (TCM), executes the appropriate upshifts and downshifts by sending a signal to one of several shift solenoids. These transmission solenoids have spring-loaded plungers inside them, which are wrapped with wire. When this coil of wire receives an electrical charge from the TCM / ECU, it causes these plungers to open, allowing transmission fluid to flow into the valve body and pressurize the desired clutches and bands. When this happens, the transmission changes gears and you continue down the road. The computer controls the transmission solenoid in several ways. If the vehicle is equipped with a dedicated Transmission Control Unit, it can open or close the hydraulic circuit using a direct 12v signal. In some cases, the Engine Control Unit (ECU) can control the solenoid’s plunger by turning the ground circuit on and off. I would recommend having a professional from YourMechanic come to your location to diagnose and inspect your transmission.

ANSWER : Hi – first task is to read any problem codes, whether the Check Engine light is on or not. Most auto parts stores will do this for you for free on a "time-available" basis. Any codes extracted are useful for diagnostic purposes. Based on your symptoms, the throttle position sensor is a leading failure possibility. A malfunctioning idle air controller could also cause the unpredictable idling issues, but not a shut-off while driving. I recommend a car stalling inspection performed by a mobile, professional mechanic, such as one from YourMechanic, who will come to your location, diagnose this problem, and give you an accurate assessment of damage and cost estimate for repairs.

ANSWER : This may also be caused by what is called the fuel pressure regulator. This is a unit that helps to maintain the fuel pressure at the proper level. When this is not working properly, the fuel pump may be pumping properly, but the fuel may not arrive at the fuel injectors at the proper psi. When this happens, this can cause a lean fuel condition which may cause the car to hesitate, misfire or stall. I would recommend having an expert from YourMechanic come to your location to diagnose your fuel pressure.

ANSWER : Your MAP sensor is an important input for your computer. It helps determine the load on the engine to calculate the correct amount of fuel to inject. It sometimes takes a few seconds for the vehicle to realize that the sensor is not producing a good signal.

At that point, it will use other methods to determine the fuel rate, such as pre-programmed fuel maps, throttle position, etc. I would suggest replacing the MAP sensor and retesting. If you would like to have it checked first, a certified technician from YourMechanic will be able to scan your vehicle and test components to determine the root cause of your starting issue before making a repair.

ANSWER : Hi there. I wouldn’t suspect that removing the battery has caused any problems. When your engine runs rough, it can be caused by multiple issues, ranging from a vacuum leak to fuel system component problems, and ignition system issues. I would recommend having one of our professional mobile mechanics come to your location and complete an engine is pulsating inspection. This will allow them to isolate the source of your issues and recommend the right repairs.