Can a 97 Gilles fit on a 95 Mercury Grand Marquis?? Because I want to get it from a pull a part plscr
Can a 97 grille fit on a 95 Mercury Grand Marquis as well as the headlights… basically the whole front end…,??
My car has 172000 miles.
My car has an automatic transmission.
Experienced mechanics share their insights in answering this question :
Hi there. The fit would be close, but might have some overhang and connectivity issues. You might want to measure your existing grill and note the location of installation screws in relation to the vehicle on both parts.
How to Identify and Fix Common car Problems ?
Our sources include academic articles, blog posts, and personal essays from experienced mechanics :
The Grand Marquis is essentially a luxurious version of the Ford Crown Victoria. It comes in two trim levels; GS and LS. The trim level can be identified by the fifth, sixth and seventh digits in the VIN. A Grand Marquis GS is represented by “M74”, while a Grand Marquis LS Premium is represented by “M75”.
Engine Oil
5W-20 (All TEMPS) – This specification has been updated from 5W-30 to 5W-20 per a Technical Service Bulletin from the manufacturer 5W-20 is the preferred viscosity.
Mercury Grand Marquis chip tuning can be done in two ways – through the OBD2 diagnostic connector or through the engine control unit (ECU). Increasing the power of Mercury Grand Marquis is done by remapping car engine. There are no worries about compatibility or unstable engine operation.
Predecessor. Mercury Marquis. Successor. Mercury Grand Marquis (1983–1991)
Engine Oil
Capacity: 6 quarts. . . . . . . . . . . . . . (with filter). After refill check oil level.
What kind of oil does a Mercury Grand Marquis need? You want to buy 5W-20 motor oil because the W indicates that it works well in winter temperatures, and is a great oil to minimize general wear and tear.
2004 Grand Marquis
The 2004 Mercury Grand Marquis is a full-size premium sedan that offers seating for up to six passengers and a 224 hp 4.6L V8.
Mercury is a defunct division of the American automobile manufacturer Ford Motor Company. Created in 1938 by Edsel Ford, Mercury served as the medium-price brand of Ford for nearly its entire existence, bridging the price gap between the Ford and Lincoln model lines.
` A `tune` is a device that will update your car`s ECU or computer and give it different instructions on how to deliver power to the engine. You will unlock your engine`s full capacity with this tune. It can add 15-30 horsepower and 20-30 lb-ft of torque on most basic cars.
A single tune will add about 10% to 15% of horsepower on average. There are cases of some tune-ups increasing the horsepower by 50% if the driver wishes it.
The average cost for Mercury Grand Marquis Timing Belt Replacement is $267.
Fuel & MPG
285.0/418.0 mi. 19.0 gal.
The 4.6 L`s bore and stroke are nearly square at 3.552 in × 3.543 in (90.2 mm × 90.0 mm), respectively. Deck height for the 4.6 block is 8.937 in (227.0 mm) and connecting rod length is 5.933 in (150.7 mm) center to center, giving the 4.6 L a 1.67:1 rod to stroke ratio.
The most widely used variant of the 4.6 liters is the two-valve (2v) version that features single overhead camshaft construction and two valves per cylinder. Depending on what year and model you find a two-valve 4.6 in, it will have between 190 and 260 horsepower and between 260 and 302 lb. -ft.
At a glance, it is challenging to tell the difference between a 4.6L iron block and a 5.4L. Where these blocks differ is deck height with the same cylinder bore size. The 5.4L block has a taller deck. It is also long on beefcake down under for strength.
The Ford 4.6L engine is a naturally aspirated V8 from Ford Motor was used to power a variety of different vehicles like sports cars, pickup trucks, sport utility vehicles, luxury sedans and cargo vans.
5W-20 (All TEMPS) – This specification has been updated from 5W-30 to 5W-20 per a Technical Service Bulletin from the manufacturer 5W-20 is the preferred viscosity.
Choosing the right motor oil for your car is very important to ensure proper engine protection and to cover any conditions that may be required to maintain your vehicle`s warranty. Motor oils can be very different and are formulated to meet certain performance specifications and SAE viscosity grade requirements.
A V8 engine has a total of eight cylinders, designed as two rows of four cylinders. V8 is common in trucks, large SUVs, and sports cars.
Taken care of your car can easily go 200,000 miles but there will be repairs along the way. 10 people think this is helpful.
Ford completely phased out the Mercury brand in 2011, as the company refocused its marketing and engineering efforts solely on the Ford and Lincoln brands.
Ford ended the production of the model in the fourth quarter of 2010. Mercury was originally created to offer Ford customers a premium vehicle. However, the popularity and corresponding sales of Ford-branded vehicles had left the Mercury brand weak, with many of its loyal customers electing to drive Ford models.
Following World War II, Ford formed the Lincoln-Mercury Division, pairing Lincoln with its mid-range Mercury brand; the pairing lasted through the 2010 closure of Mercury. At the end of 2012, Lincoln reverted to its original name, Lincoln Motor Company.
Relevant Questions and Answers :
the most relevant questions and answers related to your specific issue
Can a 97 Gilles fit on a 95 Mercury Grand Marquis?? Because I want to get it from a pull a part plscr
ANSWER : Hi there. The fit would be close, but might have some overhang and connectivity issues. You might want to measure your existing grill and note the location of installation screws in relation to the vehicle on both parts.
my question is that i want to get a nissan sliva s14 which is the 240sx i guess but when i get it i want to convert it into a gtr
ANSWER : Hello. I have seen several s14/240sx’s with the RB26 motor installed in them. I do not believe that it is a direct swap however. There is most likely some fabrication involved. If you search around on the internet i’m sure there are "kits" available that may include motor mounts and other parts that will help in the swap. The bodies of the two cars are quite different so i do not believe it is possible to swap bumpers between the cars. Also, AWD is not possible to to space constraints due to the differences in the bodies and frames of the cars. I’m not saying that I’m an expert with these cars but from what I’ve seen over the years this is what I know. I will say that given enough time, skill and money anything is possible. Have you considered swapping in a LS1 corvette motor? That is another popular swap that is pretty straight forward.
I have a 97 Pontiac Grand Prix SE and want to put a supercharger motor in it. Will it fit and can I use the SE transmission?
ANSWER : Hi, thanks for writing in. The supercharged engine will fit in your car and it should bolt up to the transmission that is already in your car. Pontiac made cars that year that had supercharged engines and I’m pretty sure the transmission is no different from the Pontiac that didn’t have a supercharged engine. It should not be a problem to put in the supercharged engine but you may also have to change the computer so the car will run right. Hope this helps and best of luck to you!
Will 96 parts fit on my 95 honda passport?
ANSWER : If you are looking for a specific USED part for your 1995 Passport, you will find the part for your model year in the on-line searchable database at Car-Part.com. You needn’t search for interchanges if you use that database as all interchanges are already built-in to the database and so if another model year (e.g., 1996), or a range of model years, will work the part for the "other" model year(s) will automatically come up in the search results. If you are looking for a new part, whether OEM or aftermarket (with OEM much preferred), if you would please identify the part we can let you know the exact range of model year application. If you have further questions or concerns, or need installation assistance for the part, do not hesitate to re-contact YourMechanic as we are always here to help you.
What is the best car starter to get for my moms car? (this is her car by The way i just want to get her one for christmas
ANSWER : There are many brands of starters on the market. I would only recommend the dealer starter as the best. You may find aftermarket starters to be rebuilt and the dealer new would be better in most cases. The aftermarket ones may give you lifetime warranties. This does not make them better but a better warranty.
Cant find brake fitting for 1/4 line going into rear rubber line with tee.
ANSWER : Your best bet would be to have a professional perform the service for you since you are having so much trouble. These are the brake lines so you really want them done right the first time and a warranty in case something goes wrong and your pedal gets soft. The old fitting will need to be cut from the old line and placed on the new line and the new line flared as the vehicle is set up which may require that expensive tool. Consider hiring an experienced technician like one from YourMechanic who can help you avoid a tow fee and come out to take a closer look at the brake system damage to offer a more personal estimate on the repairs.
Problem with the triggering system on the coil ? Can the coil go bad and get out of time on firing? 1996 Mercury Grand Marquis
ANSWER : Hello – no, the coils cannot vary timing, they are responsive to whatever timing trigger is passed to them (crankshaft or camshaft position sensor, ignition control module, distributor, etc.). The coil which services Cyl 5 could be failing however – try swapping the 2 coil packs and see if the symptom moves to another cylinder – if so, you’ve found the problem (coil failure). Misfires are tough to trace and can vary as to their cause from junk in the spark plug well causing a short, to plugs, wires or coils, leaking or clogged fuel injectors, to blown head gasket leaking coolant into that cylinder. Popping and backfiring are usually indicators for an air leak (lean condition) in the air intake. I would recommend a misfiring inspection by a mobile, professional mechanic, such as one from YourMechanic, who will come to your location, diagnose this problem, give you an accurate assessment of damage and cost estimate for repairs.
Are 1996 and 1997 toyota Previa Brake pads the same? I see some guarranteed OEM pads listed to Fit from (’91 to ’97) with one pa
ANSWER : The OEM pads specified by Toyota for 1996 versus 1997 are different insofar as the specified friction material (ceramic versus metallic). On that criteria, the pads for these two years are NOT interchangeable. Brake systems are designed with specific assumptions as to both the rotor material and friction material so OEM versus OEM for the two years are definitely different. If your question is alternatively, will the pad for the 1996 physically fit in the torque plate for both 1996 and 1997, that is unclear from the available documentation. The simple and accessible answer is if you desire to use a different friction material than OEM specified for 1997, which friction material happens to be on a backing that is specified for a 1996, all you have to do is carefully (very carefully) measure the dimensions of the 1996 backing versus what you know does fit on a 1997. If the backing for the two years is absolutely identical in every dimension, yes it possible to use it of course. But, the best thing to do by is buy brake pads and rotors from Toyota for a 1997.
