The EPS warling light just lit on my 2010 hyundai elantra but the steering seems fine. What might be the problem?
The EPS warling light just lit on my 2010 hyundai elantra but the steering seems fine. What might be the problem? Steering is fine,car is driving ok,should i be concerned?
My car has 45000 miles.
My car has an automatic transmission.
Experienced mechanics share their insights in answering this question :
Hi there. When the electronic power steering light illuminates on the dashboard, it indicates that the ECU has detected a trouble code relative to that system. It could be as simple as the connection being loose, or the sensor being damaged; especially if you’re not experiencing any physical driving issues. However, you might want to have a professional mobile mechanic come to your location complete a service light inspection to determine what is causing the light and recommend any repairs.
How to Identify and Fix Common car Problems ?
Our sources include academic articles, blog posts, and personal essays from experienced mechanics :
When the electronic power steering light illuminates on the dashboard, it indicates that the ECU has detected a trouble code relative to that system. It could be as simple as the connection being loose, or the sensor being damaged; especially if you`re not experiencing any physical driving issues.
It can sometimes be caused by a fault with the battery or alternator, so you can carefully check all connections to the battery and see if there`s any visible wear or damage. This issue with the EPS light can also be caused if you have recently had to jump-start your car, or you`ve disconnected the battery.
Government safety officials have announced a recall of more than 200,000 Hyundai Elantra vehicles, due to problems with the electronic power steering system, which may fail and require drivers to apply extra force to steer the vehicles, increasing the risk of a crash.
Hyundai electric power steering (EPS) warning light
This warning light indicates that there`s a problem with the power steering. For electric powered systems, this problem could be as simple to fix as rebooting a computer. Find a safe place to stop and try turning the car off and back on again after 30 seconds.
The Problem: Hyundai states that the electronic control unit (ECU) located within the electronic power steering (EPS) system could fail. Specifically, the ECU may miscalculate the torque applied to the steering wheel.
Electrical power steering systems use no fluid, so a top off is not an issue when the warning light comes on. In most cases, a simple technical glitch in the computer system may be the culprit, so a simple reboot is in order. All you need to do is turn off your engine, then restart it so the light can reset.
This is a serious battery problem if the battery is now swollen and has no power. There has been an obviously internal fault. This will cause the vehicle to power down and the EPS light to come on as well. The EPS light is the warning indicator for the electric power steering.
If the EPS light is always on, it means the vehicle`s computer is reporting a fault in the electronic power steering system.
You can stop the engine and then start it again – the EPS will recover for a while, but this is temporary. The soonest possible diagnostics and repair in order to restore EPS normal function is highly recommended.
As long as you are not impeded by any negative side effects and you feel it is safe to steer your vehicle, you should be ok to continue driving your Hyundai until your appointment.
Electric Power Steering (EPS) Indicator
What does it indicate – It indicates there is a problem with your electric power steering or your vehicle`s power steering fluid levels are low. Check your fluid levels to identify if they are low. If that is not the problem, take your car in to a technician to have it diagnosed.
The electric power steering system (EPS) Warning Light is located on the instrument panel. When the light is illuminated, it means that the EPS system is not functioning properly, and the vehicle should be serviced. Tip Like all warning lights, the EPS warning light briefly illuminates when the car is turned on.
The cars, manufactured between December 11, 2009, and October 31, 2010, have an issue with a circuit board that governs its electronic power steering system. The board might be damaged, which might cause power steering to magically disappear.
The subject vehicles are equipped with electronic power steering (EPS)… There are three main inputs to the system`s [electronic control unit, or ECU]; steering wheel torque, steering wheel position (angle), and vehicle speed. Two LEDs are used to calculate torque applied to the steering wheel.
The light warns you that the power steering system has failed and prompts you to investigate for a cause. The cause may vary according to the type of power steering system in your car. In hydraulic power steering systems, a leak in the system causing a low fluid level is the most common cause for this problem.
Electronic Power Steering Parts
An EPS control module, which acts as the “brain” of the system, collecting data from the other components of the system and sending it out. An EPS motor that powers the assistance function based on the information provided by the control module.
If your Electronic Stability Programme (ESP) warning light is on, this will usually indicate that you are either driving on a slippery surface or that there is a problem with your electronic stability program system.
M-type fuse.
Answered by CarsGuide. The power steering is an electrical system, so a problem with the battery could affect the power assistance. You should still be able to steer the car even without power assistance. It won`t affect the braking.
The EPS light comes on when the computer detects an issue with the vehicle`s electronic power steering system. If the computer detects an issue with the system it will set off the warning light to notify the driver of… Your vehicle is equipped with electronic power steering (EPS).
There are several factors that can affect a company`s EPS, such as changes in sales or expenses, issuance or repurchase of shares, and changes in tax laws. Companies that issue additional shares will dilute their EPS, as there will be more shares outstanding and therefore less income per share.
This problem can be fixed on your own, but if you`re not sure how to fix electric power steering problems, take it to a certified mechanic.
The purpose of ESP is to constantly monitor steering wheel angle in relation to the actual direction of travel; measuring individual wheel speed, yaw angle and steering angle 25 times per second.
Relevant Questions and Answers :
the most relevant questions and answers related to your specific issue
The EPS warling light just lit on my 2010 hyundai elantra but the steering seems fine. What might be the problem?
ANSWER : Hi there. When the electronic power steering light illuminates on the dashboard, it indicates that the ECU has detected a trouble code relative to that system. It could be as simple as the connection being loose, or the sensor being damaged; especially if you’re not experiencing any physical driving issues. However, you might want to have a professional mobile mechanic come to your location complete a service light inspection to determine what is causing the light and recommend any repairs.
This morning Engine Light, Traction Control Light, and Electronic steering light is on.
ANSWER : Hi there. The "good driver" light will not come on if there is a fault detected in the engine controls system; the other lights can accompany the check engine light as well, but there may be an additional cause for the power steering light. When the engine computer detects a fault in any system of the drivetrain, it sets a code and other systems can be affected by this. The others systems usually set codes in their computers that refer to engine computer communication has stopped. Have the codes checked and proceed with proper diagnostic steps from there. The codes are not a diagnosis, but a guide to the system that has the fault. Having a qualified technician perform an inspection will avoid replacing unnecessary parts. Your Mechanic has several available technicians that can assist you with a check engine light inspection.
Abs light, emergency brake light, steering wheel assist light, engine light, EPC light, traction control light
ANSWER : Hello, thank you for writing in. The vehicle does utilize a lot of the same sensors for these systems. Are there any other codes that are coming up when this code appears? If so you will want to take these into consideration when processing the repair and making a diagnosis. The module may be bad, and replacing it should fix the problem. The lights should turn off once the main computer recognizes the new module and the sensors sync up. If you believe the sensors need to be cleaned you may do so. Do as minimal as possible to make sure you are not damaging the sensor or disrupting the wiring inside. A bad connection would make the lights stay on. With so many lights that are effected by the module being illuminated, the module is likely bad or does not have a connection. Check the connection first and then resort to replacing the unit. For more help with these electrical tests, contact our service department.
While diriving my 2017 honda civic my dash displayed powered steering (eps) problem, what does this mean?
ANSWER : Yes, all of those issues should be checked out, especially as the warning lights involve key vehicle safety systems like the steering system. Your vehicle is under warranty as it is brand new. You should bring the car back to the dealer and have them resolve the issues at no cost to you. If the issues recur, be sure to follow up, as needed, and if the issues are not permanently resolved, in a reasonable number of visits to the dealer, keep in mind that very specific, and very protective (of the consumer) state and Federal Lemon laws apply to new vehicles. I mention all this because you are driving a brand new car and yet all these warning lights have appeared. That’s not an expected outcome and thus you should follow-up promptly and make sure this gets fully and thoroughly resolved. If you have further questions or concerns, please do not hesitate to re-contact YourMechanic as we are always here to help you.
Steering wheel shakes, light came on power steering assist failure 2010 Ford Escape
ANSWER : Hi there – this behavior, sometimes called "phantom steering shake" is often due to a steering torque sensor in the steering column. This device sense how much effort is being put into the steering wheel to make a turn. This determines how much "power assist" the electronic steering adds to your own effort to turn the steering wheel. If you are getting the "shake" while idling and still, this can be the beginnings of failure of this sensor. I would first go back to Ford to discuss the Recall (#14V284000), because this appears to be precisely the problem you are having. Escalate to Ford Customer Service. If this is unsuccessful, I recommend a steering wheel shakes inspection performed by a mobile, professional mechanic, such as one from YourMechanic, who will come to your location, confirm this diagnosis, and give you an accurate assessment of damage and cost estimate for repairs.
My Jeep started fine. I adjusted the tilt steering. The airbag light came on but it continued to run fine. Shut Jeep off and would not start again
ANSWER : The air bag light comes on when the computer detects an issue with the vehicle’s air bag safety system. This can have many potential causes, including a faulty sensor, wiring, air bag unit, computer, among other things. If you were having issues with the steering column, it may be possible that one of the airbag system components located in the steering column, such as an airbag module or sensor, has had an issue. If these components are linked to the starting system then this may be part of the reason why the vehicle is not starting. If the engine is cranking when you turn the key, then that is a good sign that the starter is getting power, so that rules out most of the no start issues related to the starting and electrical systems.
It may also be possible that the no start condition is a completely separate issue from the airbag light, as there are many things, not related to the airbag system, that can cause a no start condition. A few common non air bag related causes are issues with the fuel, ignition, or engine management systems. If any of the components to these systems, such as the fuel pump, ignition coils, or an engine management sensor, fail or have an issue, they may cause the vehicle to Retrieving the trouble codes using a scan tool capable of reading airbag system codes as they will likely shed some light on what the cause of the issue may be, or if the two are related. If you are unsure, I would recommend having a professional technician, such as one from YourMechanic, come to your location to diagnose and repair the cause of the no start condition.
No dash lights, back right tail light is out, no parking lights. Brake lights work though as does head lights.
ANSWER : Hi there. In many cases, when you have electrical problems like you’re describing, it’s caused by multiple electrical component failure. It’s likely that a few electrical relays are not working; especially if you have systems that utilize the same components (such as your brake light and tail lights). I would recommend having a professional mobile mechanic come to your location to complete an electrical problems inspection first, so they can pinpoint what is damaged and recommend the right repairs.
Electrical problems after upgrades
ANSWER : Hi there. From the description you have provided, all of your vehicle’s electrical problems began with the "upgrades". Unfortunately this could be a can of worms to repair. Assuming, you had a qualified technician install the vehicle’s radio and lighting upgrades and all was fine after the installations. This would lead me to believe your vehicle has several problems. The first place to look would be fuse(s) for the inoperative components. Next, to look for shorts to power the components staying on. If you can find the problem yourself, I recommend having your vehicle’s electrical problems diagnosed and repaired by a certified technician, like one from YourMechanic.
