Mitsubishi Eclipse automatic to manual conversion

ANSWER : There will be more than a few changes to the vehicle you will need to do to facilitate this swap. The wire harness, computer, engine and trans mounts, computer, clutch pedal assembly and other items that may not be mentioned. You should also make sure to install a new clutch assembly or at least check it.

ANSWER : Based on the interchange data that is published at Car-Part.com, the axle used for the 2006 model year is not a direct interchange for 2002. Of course, it is always possible to modify parts but that is burdensome and also risky. There are quite a few model year 2002 axle assemblies for your make and model listed for sale at Car-part.com (just use the search function) so your best bet really is to simply buy the part that corresponds to your model year and that will of course save you from experiencing any fitment problems. Should you need assistance procuring parts and installing them on your vehicle, by all means contact YourMechanic and a certified mechanic will work with you on your current project. Please let us know if you have further concerns.

ANSWER : This would depend on what the manufacturer recommends. Many manual transmissions do take automatic transmission fluid. If your transmission has ATF in it, it is very likely that it is supposed to have that in there. If not, it is likely that the transmission would not function properly with the wrong fluid. Many manual transmissions will also take engine oil as a lubricant. The best way to know for sure is to check your owner’s manual or call your local General Motors dealership to inquire.

ANSWER : Hi there. The only way that this might work is if the engine from the Eclipse is the same exact size, has the same fuel and ignition system components. However, I believe there are fuel and ignition differences between these two vehicles; so it’s likely that you would have some compatibility problems. However, we don’t offer this type of service, so I would refer you to consult with an engine swap specialist located near you.

ANSWER : Hi there. All automatic transmissions require transmission fluid for them to work. In your engine compartment by the right side next to the radiator area, there is a box in front of the air filter housing. Remove that box and below the air filter housing you will see the dipstick to the transmission. For the transmission not staying in automatic mode and conveying over to the manual mode only, the shifter has either broke inside or the circuitry has a short in the shifter housing. I recommend replacing the shifter assembly with a new one. If you need further assistance with your shifter not selecting automatic mode, then seek out a professional, such as one from Your Mechanic, to help you.

ANSWER : Your existing PCM and electronic transmission controls are not compatible with a manual transmission. Consequently, if you desire to convert the vehicle to manual operation, you will have to obtain the donor vehicle’s electrical system and carry that over to your existing vehicle. Also, if you change the transmission, the change in weight affects the suspension and alignment settings. You will be better off if you diagnose and repair what you have. If you desire to go that route, please simply request a diagnostic such as a rough running diagnostic and the responding certified mechanic will travel right to your location and get the issues you are having diagnosed and resolved for you. If you have further questions or concerns, do not hesitate to re-contact YourMechanic.

ANSWER : Hello, thank you for writing in. A swap like this can be complicated if you are not used to doing it yourself. This is something you may want to seek help with. The vehicle with the manual transmission has all of the major components that you will need. You may end up needing a separate wiring harness to connect the computer to the new transmission, but that will depend on the condition of the existing ones. Beyond the obvious swap, you also need to take into account you will have an extra pedal, and you will need to modify your vehicle to install that pedal. For more help with repairing your current automatic transmission contact our service department to schedule an appointment.

ANSWER : The PCM and TCM that you presently have are incompatible with a manual transmission. The PCM hardware and some engine controls, particularly relating to idle speed and electronic "dashpot", would be different too. The only way you could reliably do such a swap is if you changed out the vehicle’s electrical system, include the wiring harness to the transmission and engine, and even that wouldn’t be a guarantee of success if your vehicle also has a body control module (i.e., that would have to be changed out as well). Your only practical option is to have the existing transmission re-built or install a re-manufactured one. Even going that route, you have to be extremely careful and vigilant that you get an EXACT replacement, in every respect, because even minor year to year differences in electronic controls could render the unit unusable. In some locales, certified Mechanics from YourMechanic will perform engine and transmission replacements, so please inquire if you simply want to repair what you have. If you have further questions or concerns, do not hesitate to re-contact YourMechanic as we are always here to help you.