Just changed oil,how do you make change oil light go away?

ANSWER : Hi There,
As you may know, these lights are designed to come on at specific mileage intervals that are preset by the factory. When your mileage exceeds a certain amount relative to the last oil change, this will trigger the lights to come on. Typically this will include the oil light and the check engine light as there are also other basic service items that are checked during oil changes. I would recommend obtaining an owner’s manual for your car if you do not already have one. This will usually indicate the specific service intervals and recommended maintenance items for your vehicle at the various mileage intervals.

The tire pressure monitor will also come on when the air pressure in the tires has reached a specific threshold relative to the tire design specification. Tire pressure is also impacted by the outside air temperature. For every 10° drop in air temperature outside your tires will lose about 1% in PSI or inflation. As you may know, as the temperature of the air changes the density of the air changes as well causing the tire pressure to be impacted by this. When this happens, the sensors in the wheels will detect this change in tire pressure and cause the tire pressure light to come on. Aside from replacing faulty tire pressure sensors, another way to help prevent this type of fluctuation in tire pressure is by the use of Nitrogen in your tires rather than regular air. As you may know, air is approximately 78% Nitrogen, 21% Oxygen and the rest is water vapor and some other small concentrations of gases. Nitrogen is much less likely to migrate through tire rubber than oxygen. This will maintain your tire pressure much more consistently during large temperature fluctuations.

ANSWER : It is possible that they put in the wrong viscosity oil. In rare instances, a defective filter will also cause low pressure. If there is too much oil, it will aerate and cause low pressure. Be sure the oil level is really not above "max". The P2187 code will appear if the oil fill cap is not tight but it will also appear due to a myriad of causes because that code only "generally" identifies a lean running condition. Consequently, numerous parts would have to be tested including the O2 sensor, gas cap seal, manifold air leaks, any vacuum leak anywhere including PCV and EVAP systems, exhaust leaks, and fuel system faults such as failing fuel pump, clogged filter and more. Since the car has relatively low mileage, you would not expect a failed oil pump, although the pressure sensor (or switch) could be bad. However, the occurrence of the oil pressure warning light is quite coincidental to the oil change, thus I would suggest bringing the car back and asking them to redo with a new filter and double check the viscosity of the new oil that they use. If the problem persists after that, you will have to test actual operating oil pressure (at idle for instance) as well as the oil pressure switch. Finally, if the oil pressure warning light comes on continuously, unless the warning circuit itself is malfunctioning, that means the oil pressure is too low to operate the engine without damaging it. Anytime the light comes on for more than literally an instant, you should shut down the car and thus an issue like this obviously has to be repaired.

If you’d like, a YourMechanic certified mechanic can come to your home or place of business to inspect the vehicle and perform an oil pressure light is on inspection to diagnose the vehicle and suggest potential repairs.

ANSWER : You need to have the oil pressure checked to see if the oil pressure is within specifications before you condemn the engine internal problem with oil pump or crankshaft and bearings. You may want to get the dealer involved now and let them take care of getting the light diagnosed.

ANSWER : Hi there, thanks for writing in. The valve stem seals are the most common cause of this on your engine. When they fail, it requires that the cylinder heads be removed and rebuilt to fix it. The piston rings can also cause this but they are not as common. Unfortunately there is not anything, not even heavier oil that will fix this. You will need to have the heads rebuilt.

ANSWER : Hello there, you have a long series of issues going on with your 2013 Hyundai Sonata. If you keep getting a repeating oil light on than there is likely a fault in that system.

Since this fault has lasted after the engine was replaced it could be a oil pressure sensor, wiring harness fault, ECU fault, oil pump, oil strainer clogged, or low oil pressure.

To diagnose this issue properly you need a complete vehicle inspection to start from square one and identify the root cause of all this.

ANSWER : To reset the oil change reminder light on your vehicle:
Turn the ignition key to the run position, do not start the vehicle.
Press the gas pedal fully 3 times within 10 seconds.
Turn the ignition to the off position.
Wait 10 seconds and start the vehicle.
If the oil change reminder comes back, repeat the steps.

ANSWER : Hello there. Usually when the oil change warning light is illuminated on the dash after an oil change, it’s just a simple glitch in the ECU and not an indication of a major problem. However, there are some instances where this will indicate that the ECU has detected restricted oil flow or reduced or increased oil pressure. Sometimes if the oil was changed and different oil was used; it can trigger this error code. The solution to resolve this issue is to have a professional mobile mechanic come to your location and complete a warning light is on inspection, so they can either clear the code or determine what is triggering this light.

ANSWER : Hello,

From what you describe it would not appear to me that something went wrong during your oil change.

If the level is correct on the dipstick and the engine runs and sounds okay, then it is probably something else.

A likely cause for a problem such as this can be a defective oil pressure sensor, or wiring.

Virtually all vehicles have a dedicated oil sensor that will monitor oil pressure of the engine and set off a warning light if it falls to low, in order to protect the engine. If the sensor fails however, it can send a false reading to the computer or gauge, and cause the warning light to activate by mistake.

I would recommend having the vehicle’s oil pressure sensor tested for accuracy, and if necessary the engine’s oil pressure to make sure that there is no issue with the oil pump or system of the engine, as unlikely as that may be.

I’d recommend having a certified mechanic inspect the vehicle for you, they will be able to check for these failures and diagnose your Check Engine Light in order to get your car running normally again.

Regards,

Eduardo
YourMechanic