Car won’t start after sitting for 14 months

ANSWER : The issue you are having is probably due to an intermittent fault in the starter motor itself or a deficiency in the starter electrical circuit, for example a large voltage drop due to a poor ground or a high resistance connection. These issues can be readily diagnosed and resolved on a mobile basis if you request a hard starting diagnostic. If you request that diagnostic, the responding certified mechanic will get this resolved for you promptly. Based on Toyota’s Factory Service Manual, the battery should not be disconnected if the vehicle engine is running. The battery acts as a large resistive voltage sink and consequently taking the battery out of the circuit, while the alternator is still running, can create a voltage spike on the car’s electrical system which is not good for voltage sensitive components such as the engine computer. If you have further questions or concerns, do not hesitate to re-contact YourMechanic as we are always here to help you.

ANSWER : Your MAP sensor is an important input for your computer. It helps determine the load on the engine to calculate the correct amount of fuel to inject. It sometimes takes a few seconds for the vehicle to realize that the sensor is not producing a good signal.

At that point, it will use other methods to determine the fuel rate, such as pre-programmed fuel maps, throttle position, etc. I would suggest replacing the MAP sensor and retesting. If you would like to have it checked first, a certified technician from YourMechanic will be able to scan your vehicle and test components to determine the root cause of your starting issue before making a repair.

ANSWER : Hi there. This does sound like an issue with the wiring. If the check engine light is coming on every now and then this means that when it does not come on there is no power to the computer. This can be the wiring harness issue or an ignition switch problem. I would have to test for voltage to the computer when the problem is occurring to be able to find where the issue lies. If you need assistance, a certified YourMechanic technician can be dispatched to your location to inspect your vehicle’s non-start issue and suggest any necessary repairs.

ANSWER : Hi and thanks for contacting Your Mechanic. If sometimes your vehicle will start with the new alternator and sometimes it won’t, then there is a loose connection in your charging system. Check all of the wires to the alternator and to the battery. Make sure that the battery cables are clean and tight. Make sure that the wires to the starter are clean and tight. A loose ground to the ignition system will cause the vehicle to not crank over. Check all of the ground wires from the battery to the starter. Make sure that they are clean and tight. If you need further assistance troubleshooting your no start situation, then seek out a technician, such as one from Your Mechanic, that can assist you.

ANSWER : If your battery is weak or has bad connections to the battery, then you may have problems starting the vehicle intermittently. This is due to low voltage to the starter which is taking all the power, while the electronic ignition and the electric fuel pump get cut short. This will cause the vehicle not to start.

You may think the vehicle is turning over okay, but the starter is taking in all of the power just to turn over the motor. You should get the battery and it’s cables checked, as well as the charging system, for any problems by a qualified mechanic so they can diagnose the problem and do any repairs needed to prevent this problem in the future.

ANSWER : Hi There,
What you are describing sounds like an ignition coil that may be failing. Ignition coils are prone to this type of erratic functioning or heat cycling when they are beginning to fail due to the temperature fluctuations under the hood which ultimately cause them to shut down causing the car to only run after cooling down for 30-40 minutes. Ignition coils are coated with a varnish-like insulation that becomes brittle over time after being stretched then contracted repeatedly The insulation develops small fractures that open when heated and close when cooled. When open, they allow shorting of coil windings and decrease or eliminate the coil’s ability to function. This process will repeat itself continuously until the coil ultimately fails completely and must be replaced. I would recommend having a professional from YourMechanic come to your location to diagnose and inspect your ignition system.

ANSWER : Hi there. There are a number of issues that will make a car hard to start. Everything from the electrical system to the fuel system to the actual starter itself can be the problem. Finding the root cause of a hard starting engine can take some investigation. Ignoring a hard starting issue can further damage the vehicle, which will often result in a more expensive repair. You might want to have a mobile mechanic complete a car is hard to start inspection so they can pinpoint the source of the issues you’re having and recommend the right repairs be completed.

ANSWER : Hi, thanks for writing in. It all depends where the smoke is coming from. If it is from the exhaust then your engine be running rich and starting to foul out the spark plugs. Have the computer tested to see if any codes are present that could indicate what is causing the smoke. If you see smoke from the engine compartment then you may be running the engine hot due to low airflow over the radiator. Have the cooling fan checked to make sure it is running. If it is running and the vehicle has the AC running and the blower is on or near high then you may be using more energy than the alternator can keep up with. This can cause the radiator fan to not turn as fast as it should and let the temperature to rise if idled for long periods. If you would like help, consider having an expert automotive technician from YourMechanic come to your home or office to inspect and diagnose this issue for you, and make or suggest any repairs as needed.