Car loses rpms and stalls

My car started to lose its rpms and it stalls. It sometimes stays on when pressing the gas but it also makes it stall sometimes. I also heard a slushing noise behind the dashboard , which leads me to the think that the drains are backed up. I tried looking to,it behind the firewall but no luck. I also thought it would be my massive air flow , but I checked it and its breathing well. The transmission is kinda low on fluid though. Its been raining for a couple days now , I think its the drain that I heard. In not sure though . please give me a hint.

My car has 96560 miles.
My car has an aut

Experienced mechanics share their insights in answering this question :
Hi There,
The sloshing sound you are hearing is likely your radiator low on coolant. I would suggest having it flushed to be sure there are no air pockets in it.

The stalling you are referring to is likely related to a dirty or faulty idle air control valve. The idle air control valve monitors the air intake as it is mixed with fuel prior to being injected into the engine at low speeds and at idle. This valve is controlled by the vehicle’s computer and will adjust idle speed based upon other measurements such as engine temperature, intake air temperature and electrical system load or voltage. This is also an important function when starting the motor as it allows the motor to run and idle on it’s own once the motor fires. When you accelerate, the engine RPM increases, and as you let off the gas, the RPM slowly returns to the normal idling speed with the help of the idle air control valve making the transition from a higher RPM back down to idle speed while adjusting the air/fuel ratio constantly to allow this to happen smoothly. When the engine RPM drops below the normal range of about ~800 RPM, this often times will cause the engine to stall indicating a dirty or faulty idle air control valve. I would recommend having an expert from YourMechanic come to your location to diagnose and inspect your vehicle.

How to Identify and Fix Common car Problems ?

Our sources include academic articles, blog posts, and personal essays from experienced mechanics :

Common reasons for this to happen:

Low fuel pressure, dirty or defective fuel injectors, or broken fuel pump: The fuel pump is responsible for transferring fuel from the tank to the engine.

The car will stall if the valve is too clogged or when it finally fails. If, while holding the accelerator pedal down, a small amount of pressure keeps the car running at a stop, the idle control valve may require attention. In most late model cars, this problem will usually trigger the Check Engine light.
In most cases, this will occur due to an obstruction of fuel or the inability to correctly mix the right ratio of fuel to oxygen. This could be due to dirty or clogged fuel injectors, throttle body or a mass air flow senor or idle control valve that is faulty or needs to be cleaned.
The most common reasons a Honda Accord engine stalling are the fuel system, the air intake system, or the ignition system. Search our network of RepairPal Certified shops near you to speak with a technician about your issue.
Some of the most common sensors that lead to engine stalling include the mass airflow sensor (MAF), engine coolant temperature sensor (ECT) and manifold absolute pressure sesnsor (MAP). The idle air control valve (IAC) and exhaust gas recirculation valve (EGR) are also well known for causing engine stalling.
There are three major causes for a stalled engine: A lack of fuel, a lack of air flow and improper ignition. Running out of fuel is one of the most common causes of engine stalling, but dirty fuel injectors or a plugged fuel filter can also be the culprit.
There are several reasons why your Honda may hesitate during acceleration. The most common reason is a problem with the fuel system, such as a clogged fuel filter or faulty fuel injectors. Another possibility is an issue with the ignition system, such as spark plugs that need to be replaced.
If the engine stalls while idling or driving, the engine may be running out of fuel or not receiving enough fuel pressure to keep it running. The most likely cause of this kind of stalling would be a fuel pump that is not spinning fast enough or is intermittently cutting out.
Faulty spark plugs can cause the car to exhibit starting troubles. Worn out plugs does not produce sufficient sparks, which is needed for starting the engine. This results in the engine to stall and fail to start quickly.
Is Your Engine Stalling? Similar to having reduced fuel efficiency, your engine may stall if you have bad gas in your tank. Having bad gas can also mean having diluted gas in your car. This could result in your car not having enough combustible ingredients to continue to run.
Will a bad O2 sensor cause rough idle and loss of engine power? You bet. Moreover, you may also notice poor acceleration, engine misfires, and even stalling. Bad oxygen sensors disrupt all kinds of essential engine functions, including engine timing, combustion intervals, and air-fuel ratio.
A failing camshaft position sensor begins losing its ability to quickly transfer data. Mismatched fuel delivery and ignition timing, even if off by a few milliseconds, will cause your vehicle to sputter, accelerate poorly, lack power, stall or even shut off.
The most common cause of poor engine airflow is a clogged or damaged air filter. The air filter in your car protects the engine by catching all kinds of debris before it can enter the cylinder and cause more damage.
When you press down the accelerator pedal and get minimal output, it could mean you have a problem with your fuel system. The most probable issue is a clogged fuel filter. Your fuel filter works to ensure that dirt and debris do not get into the fuel system.
If your powertrain control computer is misreading idle speeds, this can cause a high idling malfunction. When your car`s throttle is malfunctioning, this can cause your car to stall or idle high. Often this is a result of dirt buildup in the air intake. Other times it can be a problem with a cracked intake tube.
A good spark will be blue-white and will be plainly visible in daylight. If a good spark is present, the problem is probably not in the ignition system. Check the fuel system and/or stark timing. Weak sparks are orange or red and may be hard to see in daylight.
The most common signs of bad spark plugs include start-up trouble, rough idling, sluggish acceleration, declining fuel economy, engine misfiring, and engine knocking.
Bad solenoid may be causing vehicle to stall.
It is commonly applied to the phenomenon whereby an engine abruptly ceases operating and stops turning. It might be due to not getting enough air, energy, fuel, or electric spark, fuel starvation, a mechanical failure, or in response to a sudden increase in engine load.
You will feel a loss in power while accelerating and at times intermittent jerks. To solve this issue find the fuel filter located in the engine bay or near the fuel tank in your car`s trunk. If the fuel filter is clogged replace it if you have the skills to do so or get it changed at your local mechanic shop.
Some electrical problems that could cause a car to stall include: Corroded, stripped or detached electrical wiring. alternator. A bad battery.
Immediately turn on the vehicle`s hazard warning lights. They`re the universal sign of distress. If you`re unable to pull completely over onto the shoulder, or if the car is stalled in a traffic lane, do not attempt to get out of the car! Similarly, never try to cross a highway on foot.
Dirty fuel injectors are only one of several engine problems that can result in rough idling and engine stalling. If you notice these issues in your car, come in for a Complete Vehicle Inspection.

Relevant Questions and Answers :

the most relevant questions and answers related to your specific issue

Could this cause ur car to stall in warmer weather? My car never stalls during winter months. But from spring on its a neverendin
ANSWER : You should have the check engine light and engine scanned to see if the engine may be running lean due to low fuel pressures or clogged injectors. You should also have the mass airflow sensor cleaned and checked for proper readings and replace if not within specifications. The vehicle runs richer in colder weather and may be the reason for not stalling. You should clean injectors, clean throttle body and idle control valve then clean mass air sensor and relearn idle.

Read Full Q/A … : Car loses rpms and stalls

Replaced alternator on car 2 times each time shows it’s charging 14v let car run for a little bit then test drive and car voltage
ANSWER : There are reports that the replacement alternators will not communicate with the engine computer and will not charge correctly. I recommend using only the manufacturer approved replacement part. It can be new or remanufactured but approved for use in the vehicle. Some lower cost alternators on the aftermarket will have charging problems since they will not communicate with the ECM on the vehicle and will stop charging.

Read Full Q/A … : Car loses rpms and stalls

I put the wrong key in my car and a few weeks later my car just shut down and it will not start I believe it’s the computer but…
ANSWER : Hi there. What had happened is the wrong key set the security to the vehicle. This is to prevent the vehicle from starting with the wrong keys. Try removing the battery cables (+) and (-) for 13 minutes. During that time, put the original key in the ignition and turn it on. Activate everything in the car even though there is no power. Then remove the key and hook up the battery cables. The computer should have reset and reset the security. If the security is still being tripped, then I recommend seeking out a professional, such as one from Your Mechanic, to help you

Read Full Q/A … : Car loses rpms and stalls

Car keeps stalling car, I think it’s the fuel pump
ANSWER : Hello – I applaud your diagnostic skills! You have certainly identified a classic failure mode of a fuel pump with extended mileage such as yours. Your fuel pump is located in the tank and is cooled by the gasoline there. With a half tank (or less) of gas, the fuel pump isn’t being cooled as well. A worn pump generates more heat and will stop working when it gets too hot. Well done! I would recommend having a professional mechanic, such as one from YourMechanic, replace your fuel pump to repair this problem.

Read Full Q/A … : Car loses rpms and stalls

The engine stalls when I put the car in reverse, but if I go past reverse into drive there is not an issue.
ANSWER : Hi there. Usually when you shift into reverse and engage the brake it will cause the engine RPM to drop; as it’s creating a load against the transmission and the engine. If the engine stalls, it may be caused by a faulty idle control valve, bad O2 sensors, or clogged fuel injectors.

In regards to the "pan", we’re not sure what you are referring, so it may be a good idea to contact one of our local professional mechanics to complete a battery inspection to determine what’s going on with your 2010 Ford Focus.

Read Full Q/A … : Car loses rpms and stalls

Car loses rpms and stalls
ANSWER : Hi There,
The sloshing sound you are hearing is likely your radiator low on coolant. I would suggest having it flushed to be sure there are no air pockets in it.

The stalling you are referring to is likely related to a dirty or faulty idle air control valve. The idle air control valve monitors the air intake as it is mixed with fuel prior to being injected into the engine at low speeds and at idle. This valve is controlled by the vehicle’s computer and will adjust idle speed based upon other measurements such as engine temperature, intake air temperature and electrical system load or voltage. This is also an important function when starting the motor as it allows the motor to run and idle on it’s own once the motor fires. When you accelerate, the engine RPM increases, and as you let off the gas, the RPM slowly returns to the normal idling speed with the help of the idle air control valve making the transition from a higher RPM back down to idle speed while adjusting the air/fuel ratio constantly to allow this to happen smoothly. When the engine RPM drops below the normal range of about ~800 RPM, this often times will cause the engine to stall indicating a dirty or faulty idle air control valve. I would recommend having an expert from YourMechanic come to your location to diagnose and inspect your vehicle.

Read Full Q/A … : Car loses rpms and stalls

My car will not start Intermittently. I purchased a new battery 2 weeks ago and yesterday the car wouldn’t start. Got a jump and
ANSWER : The issue you are having is probably due to an intermittent fault in the starter motor itself or a deficiency in the starter electrical circuit, for example a large voltage drop due to a poor ground or a high resistance connection. These issues can be readily diagnosed and resolved on a mobile basis if you request a hard starting diagnostic. If you request that diagnostic, the responding certified mechanic will get this resolved for you promptly. Based on Toyota’s Factory Service Manual, the battery should not be disconnected if the vehicle engine is running. The battery acts as a large resistive voltage sink and consequently taking the battery out of the circuit, while the alternator is still running, can create a voltage spike on the car’s electrical system which is not good for voltage sensitive components such as the engine computer. If you have further questions or concerns, do not hesitate to re-contact YourMechanic as we are always here to help you.

Read Full Q/A … : Car loses rpms and stalls

Battery and oil light come on when trying to start car, take keys out try again car starts no problem and lights go away
ANSWER : Of course, don’t switch gears without being fully stopped, unless your Owner’s Manual or the manufacturer has alternative advice. However, the gear shift issue has no relation to the no-start problem you are describing. Inasmuch as you only have 6,000 miles on the car, the "constant on and off" that you believe has occurred is meaningless in comparison to the expected total vehicle service life. That is, assume what you perceive as "constant on and off", during merely 6,000 miles, might be equivalent to using the car "normally" for three years. A new car should be trouble free for at least 5 years, unless there is a defect, so your "constant on and off" is not a causal factor for any fault on the vehicle. What you might have is a defect in the ignition switch, or perhaps the immobilizer system, but if the problem is not in the switch itself, clearly there is an electrical problem.

If your vehicle is under warranty, by law the dealer MUST repair the issue you are describing within a prescribed time frame and number of "attempts", otherwise the dealer will run afoul of Federal and state Lemon Laws that give you very specific rights, and recourse (contact an Attorney; we are Mechanics, NOT attorneys). Consequently, if the vehicle is still under warranty, to save yourself money do be sure to seek a resolution from the dealer. If the vehicle is not under warranty, obviously a certified Mechanic from YourMechanic could identify the electrical fault and resolve this for you. If you want to go that route, please simply request a no start diagnostic -electrical system and the responding certified mechanic will get this taken care of for you. If you have further questions or concerns, do not hesitate to re-contact YourMechanic as we are always here to help you.

Read Full Q/A … : Car loses rpms and stalls

Eric smoalih

I am a certified master technician with the National Institute for Automotive Service Excellence (ASE), and I have been working as an auto mechanic for over 15 years. I am passionate about my work, and I take great pride in helping people keep their cars running smoothly.