Car independently downshifts on startup

When I was slowing down, my car independently started downshifted very hard. I never shifted the transmission. This problem stopped happening for about a week and then started up again, This time the check engine light came on, but was not flashing. Now the problem is constant, both the hard downshifting and the check engine light stays on. I put it in neutral now when slowing down and this avoids more strain on the transmission. But when I shift into Drive, it hard shifts. Also, my car has a sealed trans fluid unit, so it’s probably not the fluid. I will be taking it to be serviced, but bef
Experienced mechanics share their insights in answering this question :
There seems to be a problem inside the transmission and the code that has turned on the Check Engine Light may point to it. Other vehicles having similar symptoms have had faulty torque converter clutch solenoids or line pressure solenoids. I suggest hiring an experienced technician who can check the level and integrity of the transmission fluid and diagnose the trouble codes firsthand.

How to Identify and Fix Common car Problems ?

Our sources include academic articles, blog posts, and personal essays from experienced mechanics :

An illuminated Check Engine Light is another symptom of a bad or failing downshift solenoid. If the computer detects a problem with the downshift solenoid circuit or function it will set off the Check Engine Light to alert the driver of the issue.
When the temperature drops, transmission fluids with poor cold-flow properties can thicken and cause elongated and hard shifts until the fluid has warmed up enough to flow properly. Switching to a high-quality synthetic transmission fluid will help.
Transmission Fluid Low or Poor Condition – Vehicles low on transmission fluid or that are operating with worn out or contaminated fluid are likely to experience hard shift conditions. Lack of adequate lubrication within the transmission can cause several problems, including hard shifting.
Why the Transmission Won`t Shift Gears. One reason why an automatic transmission isn`t shifting into gear has to do with the fluid. If it`s not at the right level or the incorrect type has been used, then it`ll affect the gears. Another big reason has to do with the ECM possibly going bad.
This may be a result of low transmission fluid or potentially a faulty transmission control module. A faulty transmission control module may cause a delay in acceleration or erratic shifting of gears.
Using Downshifting to Slow Your Vehicle

While downshifting can be a helpful technique when you drive a manual transmission vehicle, this practice might cause devastating damage to your automatic transmission.

Automatic transmissions that shift hard, jerk or shake during a shift change may mean your transmission fluid needs changed or fluid level is low. In manual transmission vehicles, abnormal gear shifts could indicate damaged gear synchros, worn clutches or other, more severe issues.
The Vehicle Speed Sensor measures vehicle speed. When it fails the transmission can stop shifting or shift late and harsh. A bad VSS may also inhibit overdrive and the converter clutch.
The downshift solenoid regulates the transition from a higher gear to a lower gear. It is an electronically-controlled mechanical component that allows fluid movement to engage the correct lower gear.
Shift Solenoid Repair and Replacement Cost

The overall cost to replace the shift solenoid in an automatic transmission ranges from $200 to $500 for a single solenoid. If the damage requires you to replace the entire solenoid pack the cost increases to between $250 and $700.

Automatic gearbox telltale signs include hesitation, slipping, or “trembling” during gear changes. Manuals are more likely to grind. Jerking and clunking noises are more likely to be caused by failing engine and transmission mounts.
Typically this is caused by either a sticking internal valve in the transmission, or it may be the vacuum module for the transmission. Most of the time this is caused by an internal transmission issue. If the engine is running fine and is producing the correct sensor signals then the transmission is the problem.
Idling a car can cause carbon to build up on the spark plugs and inside the cylinder, which can in turn lead to a misfire or an underperforming spark situation. Either of these issues can lead to check engine lights.
Your car jerking when accelerating and the check engine light coming on at the same time usually means you have a problem with your car`s fuel injector, ignition system, spark plugs, or catalytic converter. Scanning your car computer for trouble codes that triggered the CEL to illuminate is a good starting point.

Relevant Questions and Answers :

the most relevant questions and answers related to your specific issue

I put the wrong key in my car and a few weeks later my car just shut down and it will not start I believe it’s the computer but…
ANSWER : Hi there. What had happened is the wrong key set the security to the vehicle. This is to prevent the vehicle from starting with the wrong keys. Try removing the battery cables (+) and (-) for 13 minutes. During that time, put the original key in the ignition and turn it on. Activate everything in the car even though there is no power. Then remove the key and hook up the battery cables. The computer should have reset and reset the security. If the security is still being tripped, then I recommend seeking out a professional, such as one from Your Mechanic, to help you

Replaced alternator on car 2 times each time shows it’s charging 14v let car run for a little bit then test drive and car voltage
ANSWER : There are reports that the replacement alternators will not communicate with the engine computer and will not charge correctly. I recommend using only the manufacturer approved replacement part. It can be new or remanufactured but approved for use in the vehicle. Some lower cost alternators on the aftermarket will have charging problems since they will not communicate with the ECM on the vehicle and will stop charging.

Oil leaking from under car and "remote control car" sound when car is first started for a few minutes until it warm up.
ANSWER : Hello,
There are a number of things that could make an engine noisy when starting up. Depending on the specific type of sound you are referring to, this will determine how to properly diagnose. If there is a bit of a hissing sound, this may be a sign of a vacuum leak. If this is more of a shrieking sound, this may be a sign of a worn out or out of adjustment serpentine belt. If there is a bit of a howling or growling sound, this may be a sign of a worn out or low on fluid power steering pump. A rattling or pinging sound may be caused by an ignition problem. An engine can ping (or knock) due to an improper combustion process. A "spark knock" is the result of combustion occurring too early. Early combustion can occur from carbon buildup inside the combustion chamber, a lean air/fuel mixture, and advanced ignition timing (spark plug firing too soon). A clattering type sound may be a result of improper lubrication in the valve train which could be a more serious problem and should be addressed as soon as possible. I would suggest having an expert from YourMechanic come to your location to diagnose and inspect your vehicle to ensure everything is in proper working order.

My car will not start Intermittently. I purchased a new battery 2 weeks ago and yesterday the car wouldn’t start. Got a jump and
ANSWER : The issue you are having is probably due to an intermittent fault in the starter motor itself or a deficiency in the starter electrical circuit, for example a large voltage drop due to a poor ground or a high resistance connection. These issues can be readily diagnosed and resolved on a mobile basis if you request a hard starting diagnostic. If you request that diagnostic, the responding certified mechanic will get this resolved for you promptly. Based on Toyota’s Factory Service Manual, the battery should not be disconnected if the vehicle engine is running. The battery acts as a large resistive voltage sink and consequently taking the battery out of the circuit, while the alternator is still running, can create a voltage spike on the car’s electrical system which is not good for voltage sensitive components such as the engine computer. If you have further questions or concerns, do not hesitate to re-contact YourMechanic as we are always here to help you.

Battery and oil light come on when trying to start car, take keys out try again car starts no problem and lights go away
ANSWER : Of course, don’t switch gears without being fully stopped, unless your Owner’s Manual or the manufacturer has alternative advice. However, the gear shift issue has no relation to the no-start problem you are describing. Inasmuch as you only have 6,000 miles on the car, the "constant on and off" that you believe has occurred is meaningless in comparison to the expected total vehicle service life. That is, assume what you perceive as "constant on and off", during merely 6,000 miles, might be equivalent to using the car "normally" for three years. A new car should be trouble free for at least 5 years, unless there is a defect, so your "constant on and off" is not a causal factor for any fault on the vehicle. What you might have is a defect in the ignition switch, or perhaps the immobilizer system, but if the problem is not in the switch itself, clearly there is an electrical problem.

If your vehicle is under warranty, by law the dealer MUST repair the issue you are describing within a prescribed time frame and number of "attempts", otherwise the dealer will run afoul of Federal and state Lemon Laws that give you very specific rights, and recourse (contact an Attorney; we are Mechanics, NOT attorneys). Consequently, if the vehicle is still under warranty, to save yourself money do be sure to seek a resolution from the dealer. If the vehicle is not under warranty, obviously a certified Mechanic from YourMechanic could identify the electrical fault and resolve this for you. If you want to go that route, please simply request a no start diagnostic -electrical system and the responding certified mechanic will get this taken care of for you. If you have further questions or concerns, do not hesitate to re-contact YourMechanic as we are always here to help you.

Should I buy this car for $1700
ANSWER : Prior to buying any car, drive the car around and listen for any noises. Then do an inspection on the vehicle to make sure that it is safe to drive. All cars will need maintenance, but if the car was kept up, then the maintenance should be to a minimum.

Power steering loss, no belts are turning but the car is running fine. I also have a soft pedal. Whats wrong with my car?
ANSWER : I have only seen this situation once in my 30+ years and it turned out to be a broken crankshaft pulley. Belts are driven by the engine. The crankshaft pulley spins the belts, which in turn spin the air conditioner compressor, power steering and water pumps, and the alternator. The vehicle should be towed to your local repair shop and not driven. Without the water pump spinning to circulate the coolant, the engine will quickly overheat and result in more extensive damage.

Car crash and SRS light
ANSWER : Hey there. It is likely that your front impact sensor was damaged during the frontal collision but not with enough force to deploy the air bags. There is a threshold for how hard a vehicle must be hit in order to deploy the airbags that is set by the manufacturer that may not have been met. When the SRS light is illuminated, this means that the air bags will not deploy in the event of an accident, even if it is hit hard enough. I would recommend having the frontal collision sensor inspected and replaced if necessary by the dealer or a professional who is proficient in air bag repair.