Won’t crank over start

ANSWER : Hi there:

If you checked the oil and determined that there was no oil in the car, it’s quite possible that some internal engine components have seized up; which means there might be serious engine damage internally. Before you attempt to crank it again, please contact a professional mobile mechanic to complete a car is hard to start inspection; so they can pinpoint what is the source of your issues before it causes more damage.

ANSWER : Hi there. This does sound like an issue with the wiring. If the check engine light is coming on every now and then this means that when it does not come on there is no power to the computer. This can be the wiring harness issue or an ignition switch problem. I would have to test for voltage to the computer when the problem is occurring to be able to find where the issue lies. If you need assistance, a certified YourMechanic technician can be dispatched to your location to inspect your vehicle’s non-start issue and suggest any necessary repairs.

ANSWER : Hey there thanks for writing in about your 1998 Honda Accord. This could be a few things. A faulty ignition switch, a failing crank sensor, or possibly other faulty sensors could be the cause. To have this taken care of, consider having a certified technician, such as one from YourMechanic, come to your car’s location to diagnose and repair the hard start issue.

ANSWER : Gasoline is generally not usable after 3 to 6 months. If gasoline has been stored in the vehicle for a lengthy time, the problem is likely that there is just simply nothing to combust. The volatile components in the gas have evaporated and other compounds in the gas have turned to varnish and gum, possibly plugging up the carburetor. If the tank was drained though and the fuel in the fuel system is fresh, please simply request a no start diagnostic and the responding certified mechanic will pinpoint the cause of the no start condition. If you have further questions or concerns, do not hesitate to re-contact YourMechanic as we are always here to help you.

ANSWER : Hello. Thank you for writing in. There are several reasons your vehicle may only start when jump starting. The first and most common is a build up of resistance that is causing you to need a boost of voltage to get the engine started. This may be due to poor battery cables, a bad ground connection, a poor starter solenoid, and a couple of other issues. The first thing you want to do is perform a visual inspection of the starting system. Make sure there is no corrosion build up in the battery cables. You can also check the resistance across these wires and make sure you have a solid connection between components. You then want to make sure the starter solenoid is doing its job. It is responsible for taking the small amount of electricity sent by the ignition and turning it into a huge electrical charge that is strong enough to push over the engine with the help of some gear ratios in its favor. Do some more testing, and stick to the basics before assuming its something seriously complicated.

ANSWER : Hi there. There could be two problems here. It is possible that your battery is bad and will not take a charge from your alternator while driving. In that case every time you shut your car off you will not have enough juice to start it again. Inspect your battery – it should have at least 12.5 to 13 volts to start your car, if it doesn’t you will need to replace the battery. The second problem could be that your alternator is bad and not charging your battery, in this case you will need to replace your alternator. Both the battery and the alternator can be tested in your car. If you would like to have the car checked for you, a certified professional from YourMechanic can come to your car’s location to diagnose the starting problem and proceed with repairs.

ANSWER : Hi there. It sounds like you have a failed starter. However, without proper testing there is no way to be 100% sure. I suggest having the battery tested first with a digital battery tester that provides current voltage, cold cranking amps, and state of health. Also inspect for corrosion on the terminals and cables as this will cause excessive resistance and not allow proper voltage/amps to the starter. Other possible failures could be in the wiring harness, relay, fuses, or communication network. I suggest having a qualified technician perform an inspection to avoid replacing unnecessary parts. Your Mechanic has several available technicians that can assist you with a car does not start inspection.

ANSWER : Hi there:

Usually this issue is cased by low cranking amps inside the battery. If you’ve recently had the battery replaced, it’s possible that an electrical component that makes up the charging system might be damaged or faulty. It’s also quite possible that the main electrical relay or the starter relay is giving you fits. To know for certain what the exact issue might be on your 1989 Toyota Camry, you should have a professional mobile mechanic complete a car is hard to start inspection, so they can pinpoint the source of your issues and recommend the right repairs.