Power seat not going up.

My six-way power seat moves forward, backwards, up, and down, but I cannot adjust the recliner. It moves down, but will not go upright.
Experienced mechanics share their insights in answering this question :
Your power seat should have two different electric motors that operate it. One motor is for the lower portion of the seat that you sit on and adjusts it forward, backward, up, and down. The other motor controls the back rest portion of the seat allowing it to move up or down based on your preference. It seems the motor that controls the back rest has gone bad. I would recommend getting this inspected by a professional before going any further but the power seat motor is likely in need of replacement.

How to Identify and Fix Common car Problems ?

Our sources include academic articles, blog posts, and personal essays from experienced mechanics :

The track motor may have a broken or pinched wire. Look under the seat and see if any wires are pinched or cut from the seat moving. If the wires are all connected and not pinched, then the track motor may have failed.
First, check the fuse box to see if a fuse has blown. If so, replace the fuse and try again. If that doesn`t work, check the wiring harness for any loose or damaged wires. Finally, if all else fails, you may need to replace the power seat motor.
If you press the power seat switch and the seat doesn`t move, then the switch may be faulty. The fault could be the result of a severed wire in the switch or a dead fuse. Either way, you should take your car to a certified technician to have the switch examined and repaired.
One of the biggest signs your power seat switch is going bad or failing is the seat does not move when you push the switch. The seat may not move forward or backwards, or in any of the directions it is meant to move. If the seat is not moving at all, check the fuses to see if they have blown.
Power seats in cars use electric motors — rather than manual levers, cranks, or knobs — to adjust seat position and recline.
It sounds like the adjuster motor is failing, seat track is binding, or the switch has failed. Check for power and ground to the motor while using the switch; if they are available upon command, then the motor is faulty and in need of replacement.
The average cost for a Power Seat Switch Replacement is between $327 and $340. Labor costs are estimated between $50 and $63 while parts are priced between $277 and $277.
Pull the center of the horizontal switch up to raise the seat. Push it down to lower the seat. Adjust the seat-back angle by pushing the rear switch in the direction you want to move. Reclining the seat back can decrease the protection you get from your seat belt in a crash.
Ideally, the back of your car seat should reach the height of your shoulders. If it is slightly higher or lower but you can still rest into it, it will be fine in most circumstances. Most car seats come with adjustable headrests. Ideally, you should be able to adjust both the height and the front-to-back position.
Lean Back (A Little) The angle of your seat back should be a little greater than a perpendicular 90 degrees. At 100 to 110 degrees, the seat will put the least pressure on your back. Leaning too far back forces you to push your head and neck forward, which can cause neck and shoulder pain and tingling in the fingers.
A lift chair is a power recliner that has a lift assist technology in the scissor mechanism that allows the chair to raise up where an individual that needs help getting out of a chair can stand up easier. The chair will also allow you to recline back.
If the seat functions stopped all of a sudden then you either have a blown fuse or a bad circuit breaker. Both are common issues, especially if something is failing in the seat.
Automobile power seats can fail or break in a variety of areas. In the Chevy Impala, there`s a piece that breaks that can be repaired, if you know what you`re doing and in the Dodge Nitro, it`s the motor that needs to be rebuilt.
If there is no manual override, you may be able to disconnect the power seat motor from the vehicle`s electrical system. This will allow you to move the seat manually. To do this, you`ll need to locate the power seat fuse and remove it. Once the fuse is removed, you should be able to move the seat into position.
The fuse box is located in the luggage compartment behind the passenger side wheel well. Remove the fuse panel cover to gain access to the fuses.
The most common reason is that the car seat is not properly secured to the vehicle. Another reason may be that the car seat has been involved in a collision and is no longer functioning correctly. If the car seat moves side to side while driving, it can be extremely dangerous and should be fixed as soon as possible.
Locate the power seat switch near the side of your seat. It is usually a small lever or toggle switch just above or below the cushion area on either side of your seat. 3. Push down on the power seat switch to activate it and hold it down as you move your body in position for manual movement of your power seat Mustang .
In general, car seats expire between 6 and 10 years from the date of manufacture. They expire for a number of reasons, including wear and tear, changing regulations, recalls, and the limits of manufacturer testing.
Used in conjunction with a machine or vehicle`s safety system, operator presence switches provide a fail-safe condition (shutting down the engine, turning off cutting blades, etc.) when an equipment operator is no longer in the seat. Sealed, unsealed and high-cycle-life Hall Effect styles are available.
The track motor may have a broken or pinched wire. Look under the seat and see if any wires are pinched or cut from the seat moving. If the wires are all connected and not pinched, then the track motor may have failed.
To start the vehicle, depress the brake and turn the key in the ignition lock all the way to the right until the “Ready” indicator appears (Figure B). Please note: If too much time elapses between your first log-in with the card and setting off, hold the Mobility card up to the card reader again.
Sports cars are different. As a general rule you want to sit as low as possible with your legs straight, and your body is stretched out. This gives a nice low centre of gravity, the steering wheel is moved closer to your body, and the low seat base adds to the feeling of speed when you are driving.
For ideal seat height, lower the seat as low as possible while still maintaining your ability to see clearly through the windshield at the road ahead. This helps to reduce the vehicle`s center of gravity and help you to better “feel the road” as you drive.
You should not be able to move the car seat base side-to-side or front-to-back more than 1 inch. Make sure your base is installed at the correct recline angle. Babies must ride sitting semi-reclined to keep the airway open. Most infant car seats have built-in angle indicators or adjustors to assist you.

Relevant Questions and Answers :

the most relevant questions and answers related to your specific issue

2011 Chevrolet Camaro"Driver side power seat"…..Seat back won’t come up. Dealer says its over $4,000.
ANSWER : Without knowing what the actual problem is, it would be difficult to say which estimate is accurate. It is quite a price difference. The problem can be caused by a faulty electric motor, which may be a few hundred dollars to replace, or possible a broken seat frame or drive mechanism, which can cost much more One of our mobile technicians can come to you and check into why the seat is not working and give you a diagnosis and/or estimate for repairs.

Read Full Q/A … : Power seat not going up.

Electrical issue with window
ANSWER : Hi there. If you are still unsure after testing both components, you could always make a switched jumper wire, or use a circuit tester that is capable of acting as a switch. This way, you can avoid having to buy another switch and taking a chance that it is not the problem. Or you could supply voltage directly to the motor, in a short burst, to see if the motor functions in each direction. Just be aware that you need to be careful not to injure yourself around the moving parts. If you would like to have an expert perform this procedure for you, a qualified professional from YourMechanic can come to your car’s location to diagnose the electrical system and follow through with proper repairs.

Read Full Q/A … : Power seat not going up.

My car won’t go past 35mph
ANSWER : Hi there. From the description you provided, your vehicle has problems with the transmission again. You stated it will not shift into 3rd gear again, like before the transmission was rebuilt. If the transmission is again the problem, it should be covered under warranty. It could be a faulty shift solenoid. The shift indicator not reading properly could be a faulty transmission position sensor. If this is an overall lack of performance issue, according to your last statement, then possibly you have a restriction in the exhaust system. I recommend having your vehicle’s problems inspected and diagnosed by a certified technician from YourMechanic.

Read Full Q/A … : Power seat not going up.

My 2005 Kia Sorento doesn’t have the power to go down the road. It will start and run, but it won’t go faster than 35 mph.
ANSWER : Check to see if any vacuum lines were disconnected when your engine was serviced. A vacuum leak can cause the engine to have a loss of power under a load. If all of the vacuum lines are good, then the catalytic converter could be clogged as the exhaust having too much oxygen in the system due to the exhaust leak that you had repaired. If the catalytic converter seems to be in good shape, then the timing could be off on the engine causing the ignition sequence to be late. If you need further assistance with your vehicle having a loss of power, then seek out a professional, such as one from Your Mechanic, to help you.

Read Full Q/A … : Power seat not going up.

Hi, I have a 2003 Ford Taurus. Going down the HWY it stopped having the driving power to go. Engine is running. Pulled o er and a
ANSWER : It sounds as if you are having further issues with your transmission. If the vehicle will only go forward and not reverse, it is possible that a shift solenoid replacement will resolve the issue. It is also possible that internal transmission damage may have occured. I would strongly recommend having your transmission inspected by a qualified professionial who is proficcient at transmission diagnosis. When your vehicle is hesitating to move forward, this sounds like the transmission is slipping. Maintaining proper fluid levels is essential to proper transmission operation. Be sure to have the transmission checked for leaks as well during this inspection.

Read Full Q/A … : Power seat not going up.

I bought a used car 2010 nissan versa and when I go uphill it slows down alot. When going uphill it says go 60mph I am at that sp
ANSWER : Hi there. When a car is slow to accelerate it can be caused by multiple issues, ranging from fuel systems that are clogged or damaged to an ignition system component failure. It is also possible that something in the driveline system is dragging which causes the lack of acceleration. Since there are so many different possible issues, the best way to start the diagnosis process is to have a professional mobile mechanic from our team come to your location and complete a car is slow to accelerate inspection.

Read Full Q/A … : Power seat not going up.

removing driver electric driver seat, seat stuck all the way back.
ANSWER : Hi there. Although this video is for a GMC, the process of manually adjusting a broken electrical seat is the same.

Read Full Q/A … : Power seat not going up.

How to replace back seats into their original position (Stow & Go Dodge Caravan)
ANSWER : Hi there. This video is a good tutorial on how the stow-and-go seats are removed and reinstalled. Hopefully this will help you.

Read Full Q/A … : Power seat not going up.