it’s turning over but not wanting to start.

My vehicle turns over but doesn't want to start. We have switched out the fuel injectors, fuel pump, fuel lines and fuel filter. We have a new oil pressure switch. New spark plugs and wires.new throttle body. New rodator button. And a new transmission line. We don't know what else is wrong and why it won't crank up.

My car has 234000 miles.
My car has an automatic transmission.

Experienced mechanics share their insights in answering this question :
Checking all the basics will usually locate the problem. You didn’t mention whether you have verified good spark from the coil wire. Confirm that the plug wires are on right. That distributor turns clockwise, and the firing order is 1-6-5-4-3-2 . The ignition module and pick-up coil in the distributor can both prevent starting. Fuel pressure needs to be tested and should be at least 75 psi while cranking with the return line blocked off. A compression test will help you determine if low compression on your high mileage engine is preventing it from starting. All of this can be tested to avoid replacing parts that are working. If you would like to have your starting issue inspected by a professional, a certified technician from YourMechanic can come to your car’s location to diagnose and repair your car.

How to Identify and Fix Common car Problems ?

Our sources include academic articles, blog posts, and personal essays from experienced mechanics :

The most common reasons a Chevrolet Blazer won`t start are a dead battery, an alternator problem, or failed starter.
The most common reasons a Chevrolet S10 won`t start are a dead battery, an alternator problem, or failed starter.
The most common reasons a Chevrolet S10 Blazer won`t start are a dead battery, an alternator problem, or failed starter.
If the car cranks when you turn the key, but the engine won`t start, it could be because fuel isn`t getting to the engine. One potential reason for this could be dirty fuel injectors. Over time, the fuel injector nozzles can become clogged with rust, corrosion or debris.
When your engine cranks but won`t start or run, it could mean your engine is having trouble producing a spark, getting fuel, or creating compression. The most common causes are problems in the ignition (for example, a bad ignition coil) or fuel system (for example, a clogged fuel filter).
Connected to the battery is the alternator, which works to generate power for your vehicle`s electrical components. When you have a brand-new battery but still can`t start the car, the alternator might be the issue. Cold and damp climates may increase wear on an alternator, causing it to fail.
The crankshaft position sensor monitors the position and speed of the crankshaft and other parameters that play an important role when starting the engine. If the crankshaft position sensor is having a problem, the vehicle may have intermittent starting issues or not start at all.
Slow cranking could be the result of several possible conditions, and as you`ve suggested, the fault might reappear or worsen. Possible causes are a degraded or defective battery, faulty electrical connection, a charging system problem, a bad starter or battery rundown when parked.
The source of a “cranks, but no start” problem on your Chevy 350 distributor install is most likely incorrect distributor alignment with the harmonic balancer or a mismatched balancer and timing tab.

Relevant Questions and Answers :

the most relevant questions and answers related to your specific issue

Vehicle won’t start, once it’s jump started it only stays running until you turn it off, then it work start again without jumping.
ANSWER : Hi there. There could be two problems here. It is possible that your battery is bad and will not take a charge from your alternator while driving. In that case every time you shut your car off you will not have enough juice to start it again. Inspect your battery – it should have at least 12.5 to 13 volts to start your car, if it doesn’t you will need to replace the battery. The second problem could be that your alternator is bad and not charging your battery, in this case you will need to replace your alternator. Both the battery and the alternator can be tested in your car. If you would like to have the car checked for you, a certified professional from YourMechanic can come to your car’s location to diagnose the starting problem and proceed with repairs.

My car want start and when it do it shut down and want start until 30 minute or so. Now it want do nothing
ANSWER : When a car turns and won’t start, it is called a "crank no start". When this occurs, the first thing you need to do is see what is missing. All internal combustion motors need spark, fuel, injector pulse and camshaft timing to run. If one of these is missing, you have a crank no start. Diagnose the car and see what is missing.

The GM 3.8l motor has been installed in Buicks, Pontiacs and Chevrolets for decades. Particularly during the 90’s and early 00’s, these motors have used an ignition module with three coils mounted to it. This module is prone to just this type of failure. When it gets too hot, it quits working. When it cools off, it starts again. It can also display intermittent no start conditions. This is a pattern failure on this particular motor. Before I would ever replace the module, I would check for spark and injector pulse. If it just lacks spark, I would check for a crank sensor signal and replace the ignition module.

Before we get too far ahead of ourselves, do a few tests first:

Check fuel pressure. If there is none, check the fuse and the relay.
Check for injector pulse with a noid light. If this is missing, I would suspect a crank sensor. It could be a bad Power Control Module (PCM). (PCM’s are very rare to fail. I have never changed a PCM on one of these cars.)
Check for spark with a spark tester. If it is lacking spark but has injector pulse, suspect the ignition module.

If all these are present, I would take a compression test of all the cylinders. If camshaft timing is off, several of the cylinders will have significantly lower compression. Also, camshaft timing won’t start sometimes then not others; it will either start and run bad or it won’t start at all. It may sound like it is trying to start, but it won’t start.

If all of this sounds to daunting, I recommend booking a car is not starting inspection with YourMechanic

Good luck!

Fuel pump engages. Batery good, alternator good volts, jump start helps when wont start. Temp does not matter. Intermittent?
ANSWER : Hello. Thank you for writing in. There are several reasons your vehicle may only start when jump starting. The first and most common is a build up of resistance that is causing you to need a boost of voltage to get the engine started. This may be due to poor battery cables, a bad ground connection, a poor starter solenoid, and a couple of other issues. The first thing you want to do is perform a visual inspection of the starting system. Make sure there is no corrosion build up in the battery cables. You can also check the resistance across these wires and make sure you have a solid connection between components. You then want to make sure the starter solenoid is doing its job. It is responsible for taking the small amount of electricity sent by the ignition and turning it into a huge electrical charge that is strong enough to push over the engine with the help of some gear ratios in its favor. Do some more testing, and stick to the basics before assuming its something seriously complicated.

Car was sometimes not starting, not even cranking when i turned the key then after a few times itd start. Now it ont start at all
ANSWER : Hi there:

Without being there to inspect your vehicle, or having information about what type of car, truck or SUV you own, it’s very hard for us to give you some advice. You might want to have a professional mobile mechanic complete a car is hard to start inspection; so they can come to your location and determine why your vehicle is having these issues.

Car won’t turn over. No lights come on when I turn it. Can’t even lock my doorsvor push the seat up or back.
ANSWER : Your probably correct, it sounds as though your battery is done. But it also sounds like you have charging system issues. I’m not sure that fixing your battery and charging system will solve the problem with the car shutting off, but it’s possible that it will and it’s a darned good place to start. By contacting Your Mechanic, you can have a technician come to your home or office to check out your car and help you figure out what to do next.

Car turns off
ANSWER : The problem sounds like your alternator has stopped charging the car. This will cause the car to have weak electronics like what you are experiencing. Have the charging system double checked, and if verified as the fault, replace the bad alternator.

Cranks over start than dies
ANSWER : Hi There,
The idle air control valve is a small valve on the engine’s intake system that reads the air intake as it comes into the motor. This is controlled by the car’s ECM which uses this information to make adjustments to the air/fuel ratio depending on various inputs such as outside air temperature, intake air temperature, load and various other things. As you accelerate, your car’s engine is receiving a much higher dose of fuel than when at idle and conversely, when you let off the gas pedal, there is a sudden change in this fuel supply as a result of your foot letting off the pedal. When this happens, the job of the idle air control valve is to bring this deceleration down to a slow and smooth idle rather than suddenly cutting off the fuel supply causing the motor to die. When the idle air control valve is not working properly, this cause a disruption in this process resulting in the engine not being able to idle properly. I would recommend having a professional come to your location to diagnose and inspect your vehicle.

I’ve got a 97 Taurus. The other day, I would turn the key and the engine would turn slowly but not start. All of the lights and ra
ANSWER : You should have the battery tested after running the engine to try and charge it up. Have battery load tested to see if it can hold a load and replace it if it cannot. Then have the charging system checked to make sure it is charging at the correct rate.