Is it my battery
I got my water pump replaced about 2 months ago my thermostat normally stays at a quarter between hot and cold but if it goes halfway or past halfway when I shut my car off it will not turn back on for a couple hours but if I wait two three hours and try to turn it on it'll start right up do you think that's my battery
My car has an automatic transmission.
Experienced mechanics share their insights in answering this question :
If the car has overheated before replacing the thermostat, you could potentially have a blown head gasket. I would start by checking compression to be sure this is not the case. You can rent these at the local auto parts stores if you know how to use them properly. However, I would recommend having an expert diagnose the high thermostat readings.
How to Identify and Fix Common car Problems ?
Our sources include academic articles, blog posts, and personal essays from experienced mechanics :
If your car is overheating with a new thermostat, you could be dealing with a clog in your radiator and/or heater core, a bad water pump, a broken radiator, or any number of other coolant-related issues. The first and most important thing is not to drive your car until the issue is resolved.
The water pump moves the coolant through the system and the thermostat regulates this flow to maintain operating temperature. If the water pump has failed, the coolant will not flow through the system so the temperature will rise quickly and the heat will be concentrated on the engine.
If your vehicle has ever overheated, you will likely need to get a new thermostat. Overheating can cause serious damage to the valve as well as the thermostat housing and the hoses and gaskets that are a part of your car`s cooling system.
Blown head gaskets can happen when an engine severely overheats due to a faulty thermostat, clogged radiator, leaking water pump, radiator, radiator hose or heater hoses or when the coolant in the cooling system is not changed per the O.E.M.`s scheduled maintenance.
Faulty Thermostat
Once the engine reaches operating temperature, the valve will open and coolant will begin to flow through the engine. A faulty thermostat might remain closed even when the engine is hot, which can quickly lead to overheating.
A bad car thermostat can result in overheating and heater insufficiency. While these don`t seem serious, these symptoms of a bad thermostat can lead to permanent engine damage due to excessive heat – such as seal breakages, cracked elements, and engine detonation.
Common problems include overheating, leakage, low water pressure, noisy operation, and cavitation. These problems can be prevented or fixed by regular maintenance, inspection, and replacement of worn-out parts.
The water pump is one of the vehicle components that may never require replacement if your vehicle is well-taken care of. You can own a car for over 15 years and never have to replace the water pump. That`s not to say that it can`t develop a problem.
A dead or dying water pump cannot circulate coolant through your vehicle`s engine and, as such, the engine will overheat. The hotter the engine gets the greater the chance of serious damage, including a cracked engine block and damage to the cylinders, pistons, and head gasket.
Potential consequences of improper installation could include: Electric shock. Blowing a circuit breaker. Damaging the thermostat unit, the electrical system or even the AC/furnace unit itself.
One way to check for proper coolant circulation is to check the upper and lower radiator hoses. The upper radiator hose should be hot, around 190–200 °F. (The safest and most accurate way to get this temperature reading is with an infrared thermometer.)
It may take several hours for a newly installed electric water heater to reach normal operating temperature. If you don`t have hot water after two hours (water not even warm), first check to make sure the water heater is getting electrical power.
Thermostats fail because they become weak, stuck open or stuck closed. When a thermostat is stuck open, coolant constantly circulates and the engine takes longer to reach operating temperature.
It may take several hours for a newly installed electric water heater to reach normal operating temperature. If you don`t have hot water after two hours (water not even warm), first check to make sure the water heater is getting electrical power.
You have a faulty tempering valve or you don`t have one at all. The tempering valve mixes cold and hot water together to maintain a safe temperature. If the tempering valve is stuck in the open position or if you don`t have one at all, then this could lead to your water heating up too much.
Relevant Questions and Answers :
the most relevant questions and answers related to your specific issue
I have Chrysler 300c. Battery light came on, changed battery and alternator but power still getting drained and battery light still comes on.
ANSWER : Hi, thanks for writing in. This may be a sign of a failing starter relay. The starter relay is a small unit near the starter that directs power to the starter from the battery. When this fails, it may cause a clicking sound and will not allow the starter to engage the flywheel when you turn the key. I would suggest having a professional from YourMechanic come to your home to diagnose your starting issue to determine the solution to get you back on the road.
Battery light stays on and overnight battery drain. 2006 Land Rover LR3
ANSWER : Hi there – yes, something is going on here that’s draining your battery. Perhaps the pressure of the engine wash dislodged wiring which has shorted, or there was a chemical reaction to the cleaning solution that caused electrical damage in the alternator or voltage regulator. These componnents can be checked off of the vehicle. Vehicle wiring can be diagnosed by connecting an ammeter to the positive (red) battery cable, observe the current drain (likely less than 1 amp), then, one at a time, remove each fuse, check to see if the current drain has dropped to near 0, then reinsert the fuse. This process should identify the faulty circuit in most cases. The specific components on that circuit can then be checked for current drain problems. A professional mechanic, like YourMechanic, can come to your location, and perform this procedure for you, and replace/repair the failing component.
Battery light stays on and overnight battery drain. 2006 Land Rover LR3
ANSWER : Hello – this problem can be diagnosed by connecting an ammeter to the positive (red) battery cable, observe the current drain (likely less than 1 amp), then, one at a time, remove each fuse, check to see if the current drain has dropped to near 0, then reinsert the fuse. This process should identify the faulty circuit in most cases. The specific components on that circuit can then be checked for current drain problems. A professional mechanic, like YourMechanic, can come to your location, and perform this procedure for you, and identify, replace or repair the failing component.
Car battery light is on replaced alternator battery and starter and battery light is still on.
ANSWER : You may have a failing voltage regulator that could be allowing the alternator to supply too much or too little amperage to the battery resulting in the battery never maintaining a consistent charge as it is designed to. The voltage regulator is a unit that regulates the charging of the battery by the alternator. When the voltage regulator is not working properly, this may result in the alternator allowing too much power to be delivered to the battery resulting in damaging wires and prematurely sometimes destroying the battery. A common sign of this is usually the acid inside the battery boiling causing the battery to swell. You may also smell a bit of smoke due to things potentially getting too hot. In other cases it may result in the alternator not supplying enough power to the battery, resulting in undercharging the battery or not charging it at all. I would recommend having an expert from YourMechanic come to your location to diagnose your vehicle’s charging system.
Has new alternator, new battery when started , motor dies when battery is disconnected…my mechanics are stumped on this
ANSWER : Hello.
If replacing those particular components did not correct the issue then the next thing I would look at is the vehicle’s voltage regulator. It appears that this engine’s electrical system is equipped with an external voltage regulator that functions, or malfunctions, independently of the alternator. The voltage regulator regulates power from the vehicle’s alternator, and can cause issues with the electrical system when it malfunctions. I would test it to see if it is functioning properly. It is a silver box that should be mounted somewhere in the engine bay, usually on a wheel well. A technician from YourMechanic can come to your home or office to replace your car’s voltage regulator if necessary.
Regards,
Eduardo
Hi Roberts. How would you rate a Subaru Outback battery compared with consumer reports best rated battery like diehard, and others
ANSWER : The very first thing to do is have the battery load tested. If the battery passes a load test be sure it is NOT a marginal pass in which case you should simply install a new battery to reduce diagnostic headaches. As far as buying a new battery, there are actually relatively few battery manufacturers and so a lot of the output is identical but just carries a different brand name. You would be wise to consult "Consumer Reports", as they have already done all of the required battery research for you and so you can safely and reliably purchase whatever they deem to be a top rated battery. If and once you replace the battery, be sure to measure the output of the charging system to confirm that the alternator is properly re-charging the battery. Please let us know if you have further concerns or questions as we are always here to help you.
When changing the car battery, do you "register" the battery to the car computer?
ANSWER : Hi there. Changing the battery has nothing to do with programming a battery. If the car was flat dead with a battery that lost all of the power because the dome light was on, then when jumped the vehicle will run fine. What may need programmed when the battery is replaced is the key fob. The key fob will lose programming to the computer as the vehicle computer is reset. However, if a 9 volt battery saver was put into a cigarette lighter and the car battery was removed, then the computer will not lose its memory and be just fine. If you need further assistance with your battery, then seek out a professional, such as one from Your Mechanic, to help you.
I have a 97 Dodge caravan sport.. battery light is on, replaced battery, started and after two or three hours, battery light back
ANSWER : Hi there. Electrical issues like you are describing are typically caused by a constant parasitic drain. In most cases, this is due to an accessory relay that is faulty, allowing the component to constantly draw power from the battery. It could be other electrical problems causing this issue, so before you attempt any more repairs, it’s probably better money spent to have one of our mobile mechanics come to your location to complete a battery won’t hold a charge inspection. This will allow them to isolate the source of the drain and recommend the right repairs.