Had oil and battery changed, and now the car will not start.

ANSWER : The issue you are having is probably due to an intermittent fault in the starter motor itself or a deficiency in the starter electrical circuit, for example a large voltage drop due to a poor ground or a high resistance connection. These issues can be readily diagnosed and resolved on a mobile basis if you request a hard starting diagnostic. If you request that diagnostic, the responding certified mechanic will get this resolved for you promptly. Based on Toyota’s Factory Service Manual, the battery should not be disconnected if the vehicle engine is running. The battery acts as a large resistive voltage sink and consequently taking the battery out of the circuit, while the alternator is still running, can create a voltage spike on the car’s electrical system which is not good for voltage sensitive components such as the engine computer. If you have further questions or concerns, do not hesitate to re-contact YourMechanic as we are always here to help you.

ANSWER : Hi. There is a couple of things that could be wrong here. The battery or alternator that was just installed could be defective. Theses parts need to be tested for proper operation. There also could be a fuse, fusible link, or wiring for the battery or charging system that is blown or broken causing the battery light to come on.

The codes that you have will cause the car to shut down, run rough, or not start at all. The crankshaft sensor and camshaft sensor should be replaced. I suggest having a certified technician from YourMechanic come diagnose the charging system and check engine codes to help you proceed with correct repairs.

ANSWER : Hi and thanks for contacting Your Mechanic. If sometimes your vehicle will start with the new alternator and sometimes it won’t, then there is a loose connection in your charging system. Check all of the wires to the alternator and to the battery. Make sure that the battery cables are clean and tight. Make sure that the wires to the starter are clean and tight. A loose ground to the ignition system will cause the vehicle to not crank over. Check all of the ground wires from the battery to the starter. Make sure that they are clean and tight. If you need further assistance troubleshooting your no start situation, then seek out a technician, such as one from Your Mechanic, that can assist you.

ANSWER : Hi There,
It sounds like you may need to replace the oil cap o-ring. If you haven’t done this before there are two O-rings to replace; a small green one on the base of the filter cap stem and the large black one that seals the filter cap (which seems to be the one you are having issues with). The large O-ring sits in a small square-shaped groove that is at the base of the oil filter cap. It is very easy to not properly seat the large O-ring because the threads for the oil cap are quite large and will accept the O-ring if you are not careful. I would suggest having a professional from YourMechanic come to your location to take a look at your vehicle.

ANSWER : Of course, don’t switch gears without being fully stopped, unless your Owner’s Manual or the manufacturer has alternative advice. However, the gear shift issue has no relation to the no-start problem you are describing. Inasmuch as you only have 6,000 miles on the car, the "constant on and off" that you believe has occurred is meaningless in comparison to the expected total vehicle service life. That is, assume what you perceive as "constant on and off", during merely 6,000 miles, might be equivalent to using the car "normally" for three years. A new car should be trouble free for at least 5 years, unless there is a defect, so your "constant on and off" is not a causal factor for any fault on the vehicle. What you might have is a defect in the ignition switch, or perhaps the immobilizer system, but if the problem is not in the switch itself, clearly there is an electrical problem.

If your vehicle is under warranty, by law the dealer MUST repair the issue you are describing within a prescribed time frame and number of "attempts", otherwise the dealer will run afoul of Federal and state Lemon Laws that give you very specific rights, and recourse (contact an Attorney; we are Mechanics, NOT attorneys). Consequently, if the vehicle is still under warranty, to save yourself money do be sure to seek a resolution from the dealer. If the vehicle is not under warranty, obviously a certified Mechanic from YourMechanic could identify the electrical fault and resolve this for you. If you want to go that route, please simply request a no start diagnostic -electrical system and the responding certified mechanic will get this taken care of for you. If you have further questions or concerns, do not hesitate to re-contact YourMechanic as we are always here to help you.

ANSWER : Hello. If you put too thick of an oil in the car, then you may have damaged the engine bearings but this should not have caused oil to get in to the spark plugs unless the oil got into the intake of the engine or one of the pistons rings broke. If you ran it without oil and then tried to put oil in thinking it would be okay after that, then you were not that lucky and broke or damaged all of the rings on the pistons. If you would like to have this looked over, a certified professional from YourMechanic can come to your car’s location to inspect the stalling issue and go over all of the relevant systems for a better diagnosis.

ANSWER : Hi, thanks for writing in about the concern with the BMW 320i. If the battery was submerged in water then it’s completely possible for the battery to short out and die. Your friend will need to have the battery replaced. Also be sure to get all of the water out of the trunk. Have a certified technician, like one from YourMechanic, help you guys out if you need assistance with replacing the battery. Good luck.

ANSWER : Most older cars have oil leaks. Sealing technology has just not kept up with mechanical improvements to engines so much so that leaks often kill engines rather than mechanical problems. So, it is not unexpected at all to have an, indeed many, oil leaks on a 23 year old car. Oil leaks vary hugely in terms of severity and priority of repair. Oil leaking onto a hot engine manifold is the worst case (the oil can start a fire; at best, you are left breathing oil fumes in the cabin, as the oil burns off of the manifold) while de minimus seepage of oil at the oil drain plug or oil pan gasket, while annoying and messy, if limited enough is not an emergency. Some leaks are easy to repair, while others literally require the engine to be removed just to get physical access to all the leak points. In your circumstance, if you smell burning oil, oil is probably leaking onto a hot engine part such as the exhaust manifold. A certified Mechanic, dispatched by YourMechanic right to your location, can perform an oil leak diagnostic and then let you know of your repair options and costs.

As far as the check engine light, that is not related to the oil leak(s). If you request a check engine light diagnostic, a certified mechanic from YourMechanic would use a code scanner to retrieve the specific diagnostic trouble code(s) from your car’s PCM that have caused the check engine light to illuminate. Using those codes, the appropriate individual vehicle components or sub-systems (often a sensor, circuit, and the like) are then carefully tested, based on specifications set forth in your car’s Factory Service Manual, to pinpoint the cause of the fault or the reason why the check engine light has illuminated. Once the faulty part or component is identified, it is explained to your satisfaction and the mechanic will let you know of the cost to repair. If you have further questions or concerns, do not hesitate to re-contact YourMechanic as we are always here to help you.