Engine is hot and my car won’t start off while driving.

My car engine is hot and my car shut off while driving it do you know what the problem could be? I have a 99 Nissan Altima

My car has 314751 miles.
My car has an automatic transmission.

Experienced mechanics share their insights in answering this question :
It sounds like there is a possibility of engine damage. If the engine was overheated and shut off during continued use, then the chance that engine damage occurred is high. The fact that it now does not start is also an indicator of possible internal damage. Without being there personally to check for codes, compression, cooling system integrity, etc.., it’s hard to lead you in a specific direction other than to check those things: codes, compression, cooling system integrity. I strongly suggest having a qualified technician perform an inspection to avoid replacing unnecessary parts. Your Mechanic has several available technicians that can assist you with a car does not start inspection and a car has overheated inspection.

How to Identify and Fix Common car Problems ?

Our sources include academic articles, blog posts, and personal essays from experienced mechanics :

If the torque converter is broken, or if there is a low fluid level in the transmission, the converter will not do its job, and the car will be unable to maintain power at low speeds, which causes the engine to shut off. A defective TCS or torque converter solenoid can also cause this issue.
The most common reasons a Nissan Altima is overheating are a coolant leak (water pump, radiator, hose etc.), the radiator fan, or a failed thermostat. Coolant leak (water pump, radiator, hose etc.)
The most common reasons a Nissan Altima won`t start are a dead battery, an alternator problem, or failed starter.
One of the most common causes for a Nissan not starting is due to an issue with the battery. The first thing to do is make sure all of the connections are on tight, as this can sometimes cause problems with starting.
A failing fuel pump is one of the faults that can cause this. Other likely problems would be the battery, alternator, battery cable, wiring harness fault, crank or camshaft position sensor. The fuel pump may have been replaced because it was not turning on.
The alternator helps to manage the supply of electricity by recharging the battery. When there is a bad alternator, your car will shut off while driving. This primarily happens as it affects the power supply. Alternator issues will make the engine lose power.
If the car cranks when you turn the key, but the engine won`t start, it could be because fuel isn`t getting to the engine. One potential reason for this could be dirty fuel injectors. Over time, the fuel injector nozzles can become clogged with rust, corrosion or debris.
The most common reason cars don`t start is a dead or faulty battery. Even though most cars run on gasoline, they all require electrical power to function. The starter that cranks your engine to start requires an electrical signal to fire. If something`s wrong with your battery, your car engine won`t turn over.
Perhaps your battery`s dead, or your alternator, which charges the battery, isn`t working correctly. If the source of the clicking is electrical, the starter (a small motor energized by the battery that gets the engine running) doesn`t have enough juice to stay powered.
Bad Sensors

One common culprit for this problem is the crankshaft position sensor, which measures the position and speed of the crankshaft. The computer uses the information from this sensor to know when to fire the spark plugs. If the sensor isn`t working, the spark plugs won`t fire, keeping the engine from starting.

If the engine continues to run just as before you turned it off – as if you hadn`t turned it off at all – your ignition and fuel system are not shutting down. In that case, your car has an electrical problem that needs to be addressed. Either your ignition switch element or a power relay needs to be replaced.
If the vehicle randomly shuts off while driving or stationary, there is usually an issue with the engine. Typical patterns here are issues with the ignition system, mixture preparation or fuel. A known error here is that the vehicle was refueled with the wrong type of fuel.
If the vehicle randomly shuts off while driving or stationary, there is usually an issue with the engine. Typical patterns here are issues with the ignition system, mixture preparation or fuel. A known error here is that the vehicle was refueled with the wrong type of fuel.
Anything that interferes with the spark plugs doing their job can bring your vehicle to a stop. This can result from problems with the plugs, a camshaft sensor, plug wire, caps, rotors, ECU, crankshaft or distributor.
A lack of fuel pressure or fuel volume can easily lead to engine stalling. Common culprits include a faulty fuel pump or fuel pump relay. A clogged fuel filter or bad fuel pressure regulator is also common on return-type fuel systems. Another often overlooked problem is the vehicle simply being out of fuel.

Relevant Questions and Answers :

the most relevant questions and answers related to your specific issue

Car won’t start. The check engine light, battery light, and oil change light are coming on. I tried jumping the car and nothing happened. Why won’t my car start?
ANSWER : Hi and thanks for contacting Your Mechanic. If sometimes your vehicle will start with the new alternator and sometimes it won’t, then there is a loose connection in your charging system. Check all of the wires to the alternator and to the battery. Make sure that the battery cables are clean and tight. Make sure that the wires to the starter are clean and tight. A loose ground to the ignition system will cause the vehicle to not crank over. Check all of the ground wires from the battery to the starter. Make sure that they are clean and tight. If you need further assistance troubleshooting your no start situation, then seek out a technician, such as one from Your Mechanic, that can assist you.

Can front wheel drive car engine power rear wheel drive
ANSWER : Anything is possible with enough engineering. The changes you are looking at would take major structural changes and would definitely not be an easy job. You could possibly consult a manufacturing engineer to get more details on how this could actually be carried out and whether it would be feasible.

Whenever I drive 1.5 miles, the s3 light starts blinking and then when I stop my car and come back to it, the car won’t start.
ANSWER : Hello, thank you for writing in. It is difficult to determine the issue without some more information. To start, when the check engine light illuminates, you want to scan the vehicle for diagnostic codes. These are what set the check engine light off, and are meant to tell the driver what the computer has detected is wrong. Codes can be pulled at most automotive parts stores, and by most technicians. Once you have that information you can focus in on one component or system. If the engine is truly overheating, then you want to start by checking your coolant and fluid levels. For more help with diagnosing and resolving the issue, contact our service department to schedule an appointment.

The car crank but won’t start
ANSWER : Hi there. This does sound like an issue with the wiring. If the check engine light is coming on every now and then this means that when it does not come on there is no power to the computer. This can be the wiring harness issue or an ignition switch problem. I would have to test for voltage to the computer when the problem is occurring to be able to find where the issue lies. If you need assistance, a certified YourMechanic technician can be dispatched to your location to inspect your vehicle’s non-start issue and suggest any necessary repairs.

My car will not start Intermittently. I purchased a new battery 2 weeks ago and yesterday the car wouldn’t start. Got a jump and
ANSWER : The issue you are having is probably due to an intermittent fault in the starter motor itself or a deficiency in the starter electrical circuit, for example a large voltage drop due to a poor ground or a high resistance connection. These issues can be readily diagnosed and resolved on a mobile basis if you request a hard starting diagnostic. If you request that diagnostic, the responding certified mechanic will get this resolved for you promptly. Based on Toyota’s Factory Service Manual, the battery should not be disconnected if the vehicle engine is running. The battery acts as a large resistive voltage sink and consequently taking the battery out of the circuit, while the alternator is still running, can create a voltage spike on the car’s electrical system which is not good for voltage sensitive components such as the engine computer. If you have further questions or concerns, do not hesitate to re-contact YourMechanic as we are always here to help you.

Car won’t start after seeing engine hot turn a/c off warning light.
ANSWER : Hi there. Check the battery cables and make sure that they are tight and clean. Then check the battery voltage and see if it has a voltage of 12.6 or 12.4. If the battery is less than that, then the battery needs charged. If the battery has 12.4 volts or higher, then place a load tester on the battery and see if the battery can hold a charge when a load is applied. If the battery drops under 9.6 volts, then the battery is no good and needs replaced. If the battery drops to 11.5 volts, then there is a dry cell and possible a burned cell and the battery needs replaced. If you need further assistance with testing your car battery, then seek out a professional, such as one from Your Mechanic, to help you.

Map sensor car won’t start up good ?
ANSWER : Your MAP sensor is an important input for your computer. It helps determine the load on the engine to calculate the correct amount of fuel to inject. It sometimes takes a few seconds for the vehicle to realize that the sensor is not producing a good signal.

At that point, it will use other methods to determine the fuel rate, such as pre-programmed fuel maps, throttle position, etc. I would suggest replacing the MAP sensor and retesting. If you would like to have it checked first, a certified technician from YourMechanic will be able to scan your vehicle and test components to determine the root cause of your starting issue before making a repair.

Car won’t start after driving any distance. I have to let it cool down before I can start the engine again.
ANSWER : It’s curious that you don’t seem to have a code in the ECM. Usually if you have a malfunction that prevents the car from starting, there will be a code resulting. That being said, it sounds like you may have an issue with a crank position sensor or an ignition control module. Both of these have a history of failing when they are hot and coming back to life again when they are cold. A bad crank sensor will almost certainly result in a code, but an ignition module might not. It’s hard to say what the issue is about the door lock, but it is probably not related.

Both of those pieces are pretty expensive, so I don’t recommend just replacing them to see if it works. Your best course of action would be to have a mechanic check it out so you don’t replace anything you don’t need. YourMechanic can send a technician to your home to diagnose the starting problem firsthand and recommend an accurate fix.