Does not start

car was runing good and now only turn but not stard
My car has an automatic transmission.
Experienced mechanics share their insights in answering this question :
Hi There,
Depending on whether or not the vehicle will turn over or not depends on what the next step should be. If the engine does not turn over, I would recommend checking all connections related to the battery and check to be sure the starter relay is producing power to the starter. If the engine does turn over, this may be related to a spark or fuel supply problem. Things like ignition coils, crankshaft position sensor, spark plugs, spark plug wires or ignition module are all components that help to create spark and control ignition timing which may cause the motor to not produce spark or the correct timing needed to ignite the fuel in the motor. In the case of a fuel delivery problem, this may be related to low fuel pressure, faulty or dirty fuel injectors, a faulty or dirty idle air control valve (this relays information about air intake to the computer which makes fuel adjustments), or potentially a faulty fuel pressure regulator or fuel pump. Fuel delivery problems will typically not allow the proper amount of fuel to be delivered to the cylinders which results in a lean fuel condition which can cause backfiring or simply cause the motor not to start as a result of fuel starvation. In some cases too much fuel may be supplied to the motor causing too much fuel to be introduced to the motor faster than what it can burn it. This results in the motor being flooded with too much fuel also causing it not to run properly. Any of the above possibilities can create an imbalance in the proper air/fuel ratio as well which will cause the motor to run very rough or not at all. I would recommend having an expert from YourMechanic come to your location to diagnose and inspect your vehicle.

How to Identify and Fix Common car Problems ?

Our sources include academic articles, blog posts, and personal essays from experienced mechanics :

The most common reasons a Ford Mustang won`t start are a dead battery, an alternator problem, or failed starter. Search our network of RepairPal Certified shops near you to speak with a technician about your issue.
If the car cranks when you turn the key, but the engine won`t start, it could be because fuel isn`t getting to the engine. One potential reason for this could be dirty fuel injectors. Over time, the fuel injector nozzles can become clogged with rust, corrosion or debris.
Trying to start your car without much gas in the tank? This may be the problem! Many cars simply won`t start at all if there is a very low fuel level in the tank, even if there`s enough fuel to drive for a few miles. In general, it`s a bad idea to drive around with an extremely low fuel level in your tank.
The most common reasons a Ford Focus won`t start are a dead battery, an alternator problem, or failed starter.
The most common reason is simply running out of gas. However, if you have a full tank of fuel, and your car still dies, then there is more to it than a lack of gas. You might have a clogged filter or a bad fuel pump, for example. Both of these issues prevent your engine from getting enough fuel.
Connected to the battery is the alternator, which works to generate power for your vehicle`s electrical components. When you have a brand-new battery but still can`t start the car, the alternator might be the issue. Cold and damp climates may increase wear on an alternator, causing it to fail.
Car suddenly stalls while operating: One of the most common symptoms of a failed ignition relay is a car that suddenly stalls while operating. If the ignition relay shorts, burns out, or otherwise fails while the engine is operating it will cut off power to the fuel pump and ignition system.
The fuel pump shut-off switch has a red reset button on top of it.
The 2000 Ford Mustang`s fuel pump relay location is in the constraint control relay module (CCRM). You can find this on the passenger side fender above the wheel well, although you`ll probably need to remove the fender liner to access it.

Relevant Questions and Answers :

the most relevant questions and answers related to your specific issue

Fuel pump engages. Batery good, alternator good volts, jump start helps when wont start. Temp does not matter. Intermittent?
ANSWER : Hello. Thank you for writing in. There are several reasons your vehicle may only start when jump starting. The first and most common is a build up of resistance that is causing you to need a boost of voltage to get the engine started. This may be due to poor battery cables, a bad ground connection, a poor starter solenoid, and a couple of other issues. The first thing you want to do is perform a visual inspection of the starting system. Make sure there is no corrosion build up in the battery cables. You can also check the resistance across these wires and make sure you have a solid connection between components. You then want to make sure the starter solenoid is doing its job. It is responsible for taking the small amount of electricity sent by the ignition and turning it into a huge electrical charge that is strong enough to push over the engine with the help of some gear ratios in its favor. Do some more testing, and stick to the basics before assuming its something seriously complicated.

Read Full Q/A … : Does not start

Vehicle won’t start, once it’s jump started it only stays running until you turn it off, then it work start again without jumping.
ANSWER : Hi there. There could be two problems here. It is possible that your battery is bad and will not take a charge from your alternator while driving. In that case every time you shut your car off you will not have enough juice to start it again. Inspect your battery – it should have at least 12.5 to 13 volts to start your car, if it doesn’t you will need to replace the battery. The second problem could be that your alternator is bad and not charging your battery, in this case you will need to replace your alternator. Both the battery and the alternator can be tested in your car. If you would like to have the car checked for you, a certified professional from YourMechanic can come to your car’s location to diagnose the starting problem and proceed with repairs.

Read Full Q/A … : Does not start

Cranks over start than dies
ANSWER : Hi There,
The idle air control valve is a small valve on the engine’s intake system that reads the air intake as it comes into the motor. This is controlled by the car’s ECM which uses this information to make adjustments to the air/fuel ratio depending on various inputs such as outside air temperature, intake air temperature, load and various other things. As you accelerate, your car’s engine is receiving a much higher dose of fuel than when at idle and conversely, when you let off the gas pedal, there is a sudden change in this fuel supply as a result of your foot letting off the pedal. When this happens, the job of the idle air control valve is to bring this deceleration down to a slow and smooth idle rather than suddenly cutting off the fuel supply causing the motor to die. When the idle air control valve is not working properly, this cause a disruption in this process resulting in the engine not being able to idle properly. I would recommend having a professional come to your location to diagnose and inspect your vehicle.

Read Full Q/A … : Does not start

Why does my car struggle to start every 4th to 5th time?
ANSWER : It sounds like your starting issues may be linked to a problem with air metering or fuel delivery. A clogged or malfunctioning idle air control valve may show some of the same symptoms you are describing. The idle air control valve can be stuck in a cold start position which may work well if the car has been sitting a few hours, but as the engine warms up there must be a regulation in airflow. Consider hiring an experienced technician like one from YourMechanic who can come out for a closer look at your hard start situation and offer a more personal diagnosis.

Read Full Q/A … : Does not start

When I start my car it doesn’t start after the jump start it started but later it didn’t and the battery was last replaced on 9/2012
ANSWER : As you may know when jump starting the car, the battery power provided is being supplied form the other car you are using to jump your car with. If the car does not start following the jump, this would suggest your battery may be dead and needs to be replaced. If the battery was last replaced in 9/2012, it is most likely time for a new battery as that is a decent amount of life for a battery.

Read Full Q/A … : Does not start

Car was sometimes not starting, not even cranking when i turned the key then after a few times itd start. Now it ont start at all
ANSWER : Hi there:

Without being there to inspect your vehicle, or having information about what type of car, truck or SUV you own, it’s very hard for us to give you some advice. You might want to have a professional mobile mechanic complete a car is hard to start inspection; so they can come to your location and determine why your vehicle is having these issues.

Read Full Q/A … : Does not start

My car will not start Intermittently. I purchased a new battery 2 weeks ago and yesterday the car wouldn’t start. Got a jump and
ANSWER : The issue you are having is probably due to an intermittent fault in the starter motor itself or a deficiency in the starter electrical circuit, for example a large voltage drop due to a poor ground or a high resistance connection. These issues can be readily diagnosed and resolved on a mobile basis if you request a hard starting diagnostic. If you request that diagnostic, the responding certified mechanic will get this resolved for you promptly. Based on Toyota’s Factory Service Manual, the battery should not be disconnected if the vehicle engine is running. The battery acts as a large resistive voltage sink and consequently taking the battery out of the circuit, while the alternator is still running, can create a voltage spike on the car’s electrical system which is not good for voltage sensitive components such as the engine computer. If you have further questions or concerns, do not hesitate to re-contact YourMechanic as we are always here to help you.

Read Full Q/A … : Does not start

My Blazer will crank over but not start by itself. It needs starting fluid to start.
ANSWER : Hi there. If you have not replaced your EGR valve, mass air flow sensor or the TPS on your Blazer, you might want to start with these repairs. It is also possible that the throttle body itself is damaged, especially if you’re able to start it on fluid. If you want to avoid chasing parts and repairs, the best solution may be to have a professional mobile mechanic come to your location and complete a car is hard to start inspection.

Read Full Q/A … : Does not start