Dashboard warning

A symbol of a 🔧Saying service now just came from Las Vegas to pheonix

My car has 50000 miles.
My car has an automatic transmission.

Experienced mechanics share their insights in answering this question :
Hi There,
The wrench symbol simply means the car is due for a service. According to the Nissan service manual, your car is due for the following 50,000 mile service:

❑ Replace engine oil and filter1
❑ Rotate tires (except all 370Z)2
❑ Inspect the following:
__ Automatic transmission3
__ Brake lines & cables
__ Brake pads, rotors, drums & linings
__ CVT fluid4
__ Differential oil5
__ Drive shaft boots
__ Engine drive belts
__ Manual transmission oil
__ Propeller shaft (4WD/AWD/RWD)
__ Transfer case oil (4WD/AWD)

I would suggest having a professional from YourMechanic come to your location to diagnose and perform the required services on your vehicle.

How to Identify and Fix Common car Problems ?

Our sources include academic articles, blog posts, and personal essays from experienced mechanics :

Master Warning Light

It can indicate problems that are easy to fix, such as a loose fuel cap, but it can also indicate larger problems, such as overheating within your AWD system. If this light activates during driving, reduce your speed, prepare to pull over, and check your information display for more details.

Low tire pressure: In the case of low tire pressure in one or more of your Rogue`s tires, the tire pressure monitoring system will light up its corresponding light that will appear as an exclamation in parentheses.
What Is the Meaning of the Car With Key Symbol Appearing on the Dashboard? The car with key symbol indicates that the anti-theft system is in operation. This light is a confirmation that the security systems are properly functioning.
Automatic Emergency Braking (AEB) System– This light resembles two cars crashing head-on with each other. This light will briefly illuminate when the car starts, and tells you when the AEB system is set to OFF on the vehicle information display.
As previously mentioned, a master warning light is an indicator of an issue with one of several systems. This light can indicate a malfunction in the brake switch or battery management system on some Mazda vehicles. Typically, though, the master warning light will come with a warning message specifying the issue.
You might notice the orange exclamation mark on your dashboard. It`s a common symbol often surrounded by a tire icon. If you see this symbol, pay attention. It`s an alert that one of your tires has dropped below 75% of its recommended pressure. It`s an easy fix: You need to inflate the tire.
Low Tire Pressure Warning Light: If you see a yellow exclamation point surrounded by half-circles, your tire pressure may be low, or your tires may be slowly losing air. Fill your tires to the recommended PSI as soon as possible. After filling your tires and driving a mile or two, this light should turn off.
That`s the Security Indicator Light , and it`s blinking, it`s telling you that the car`s security sytem is armed. When the car is locked and off, the Security Indicator Light will blink steadily. It will trigger shortly after the engine has been turned off and the key has been removed from the ignition.
Red warning lights mean you should stop the car as soon as it`s safe. Yellow warning lights mean that action is required.
Forward collision warning systems warn you of an impending collision by detecting stopped or slowly moved vehicles ahead of your vehicle. Forward collision warning use radar, lasers, or cameras to scan the road ahead while you drive.
“💥” U+1F4A5 Collision Symbol Unicode Character.
Collision sensors are usually mounted on the front and rear of the vehicle. Once an object is detected, the sensor triggers an audio or visual alarm, or may activate the vehicle`s brakes.
The check engine light is usually the most serious and feared warning because of the kind of damage it can signal. This warning often indicates the potential for serious engine damage. When ignored, your vehicle could suffer from a blown head gasket or a seized engine.
If these lights come on, pull over and shut off the engine as soon as you can. Some cars may have a red check engine light to alert you to stop right away, while a yellow light stands for investigation. Take it easy!
The first thing you can try, to turn off the car, then restart the engine. The second step is to disconnect your battery, wait for a few minutes then reconnect the battery. Another option is to continue to drive your car, and hope the light will reset itself.
Right-click the [Start] icon on the taskbar①, then select [Device Manager]②. Right-click the device with the yellow exclamation mark③, then select [Update driver]④. Select [Search automatically for drivers]⑤. Windows will search your computer for the best available driver and install it on your device.
A yellow triangle next to a device means Windows has identified a problem of some kind with that device. The yellow exclamation mark provides an indication of a device`s current status and could mean there`s a system resource conflict, a driver issue, or, frankly, almost any number of other things.
Master Warning: Appearing as an exclamation point inside a triangle, the master warning light can point to a minor or major problem. It could indicate something like a loose fuel cap, but it could also mean you have an overheated all-wheel drive system.
The Master Warning light is used to notify you of a potential problem with one or more of your vehicle`s advanced systems. It will be accompanied by a message in your car`s vehicle information display with a more detailed system message.
If you`re driving with a loose fuel cap, an open trunk or door, or low fuel levels, you`ll see the Master Warning Light come on. The Master warning light is an exclamation point inside of a triangle.
The Master Warning light is used to notify you of a potential problem with one or more of your vehicle`s advanced systems. It will be accompanied by a message in your car`s vehicle information display with a more detailed system message.
The Master Warning Light indicates problems with the Master Warning System. We strongly recommend that you get your vehicle checked immediately by an experienced technician.
The Master Warning light is used to notify you of a potential problem with one or more of your vehicle`s advanced systems. It will be accompanied by a message in your car`s vehicle information display with a more detailed system message.

Relevant Questions and Answers :

the most relevant questions and answers related to your specific issue

Dashboard warning lights come on during acceleration
ANSWER : Hello. Thanks for writing in about your Infiniti EX35. It sounds like one of your sensors for the system is reading incorrectly. I usually check the tires first as an odd tire on the car will cause this. If the tires are fine, then a scan tool would need to be used to see what the other sensors are reading. Most of the time, it is caused by the yaw sensor or the steering angle sensor. If you want to have this repaired, consider YourMechanic, as a certified mechanic can come to your home or office to determine the cause of the Warning Lights and let you know what needs repair.

Read Full Q/A … : Dashboard warning

My Accord gives out a "Charging system failure" warning. I drove home about 15 miles and then parked my car. After about 3 hours,
ANSWER : Hi there. On a new Honda Accord, the Charging System Failure warning light typically indicates a problem with the battery, alternator or other component inside the charging system of your vehicle. However, with less than 10,000 miles, this is most likely an electrical glitch or stored error code that was triggered. Since your car is "new", I would recommend contacting your Honda dealership first, to tell them about this warning light and ask them how they wish to handle this issue; as it should be covered under warranty. If they can’t help you, please set up a warning light inspection, and one of our mobile mechanics can come to your location and determine why this light came on.

Read Full Q/A … : Dashboard warning

Open door warning on the dash
ANSWER : Hi there, thanks for writing in about your 2009 Ford Flex. The small door ajar switch in one of the doors is sticking and will move after it warms up. The switch should be replaced in the door it is sticking in. The switch is mounted in the door latch. Sometimes the door latch can be cleaned and re-lubed and it will loosen the switch up. If you still need help having this resolved, you could enlist the help of a technician from YourMechanic to inspect and repair your door issue.

Read Full Q/A … : Dashboard warning

What is the difference between engine oil warning light and another warning light just like that but with waves under the sign? 1996 Mitsubishi Galant
ANSWER : Hello- the warning light you mention is a " low coolant" indicator. Once the engine is cool – check your coolant reservoir and/or cooling system for proper fluid level. Since you seem to have lost fluid, I would recommend an inspection of the cooling system by a mobile, professional mechanic, such as one from YourMechanic, who will come to your location, diagnose this problem, give you an accurate assessment of damage and cost estimate for repairs.

Read Full Q/A … : Dashboard warning

When the engine is started, warning lights show up on the dash for a moment and then go away.
ANSWER : Hello. This is perfectly normal. These lights come on at this time as the computer is testing them. As long as the lights are going off once the vehicle is started then there are not any problems.

Read Full Q/A … : Dashboard warning

Battery warning popped up for Hyundai Accent 200
ANSWER : This may be a sign of a weak battery, a failing voltage regulator or failing alternator. As you may know, the alternator is responsible for charging the battery while the engine runs by generating amperage and recharging the battery while the engine turns the alternator. The voltage regulator is a unit that regulates the charging of the battery by the alternator and maintaining a certain amperage while the engine runs. When the alternator is not working properly, this may result in the battery quickly losing charge and the car losing all power as you have described. You may also notice a whining sound as a result of the bearings inside the alternator begin to fail. I would recommend having an expert from YourMechanic come to your location to diagnose and inspect your charging system.

Read Full Q/A … : Dashboard warning

Car shut down and will not start. Warning lights are on – 2006 Toyota Highlander
ANSWER : Hello. From what you describe, it would appear that your vehicle is having some sort of electrical issues. The "Generator Inverter Performance" warning comes on when the computer detects an issue with the vehicle’s electrical generator inverter. The generator inverter is the component that converts the high current electricity from the vehicle’s hybrid battery into a lower power form of electricity that is useable by the vehicle’s various systems.

The inverter is located in the engine bay, as the silver box on top of the engine. Unfortunately, the inverter is a critical component to the functionality of the hybrid system, and therefore to the operation of the vehicle, and, as a result, needs to be repaired or replaced before the vehicle will run again.

The VSC system warning light comes on when the computer detects an issue with the vehicle’s stability control system. This is usually due to a fault with the wheel speed sensors or the ABS module, though electrical issues can sometimes effect this system as well and cause it to behave erratically. I would start by taking care of the generator inverter issue and going from there.

I recommend having a certified mechanic, such as one from YourMechanic, perform an inspection to determine why the warning lights are on and suggest any needed repairs.

Read Full Q/A … : Dashboard warning

How do I adjust the collision warning Warning Light?
ANSWER : The collision warning system is an important safety feature that lets you know when your vehicle is in danger of a collision. The collision warning system alerts you with both a chime and a warning light, but the warning light can be turned on or off. To do so, follow these steps:
1. Press the Up/Down buttons on the steering wheel until Settings is displayed on the instrument panel, then press the OK button.
2. Press the Up/Down buttons until Driver Assist is displayed, then press the OK button.
3. Press the Up/Down buttons until Collision Warning is displayed, then press the OK button.
4. Press the Up/Down buttons until Warning is displayed, then press the OK button.
5. Select On or Off.

Read Full Q/A … : Dashboard warning