Car wont start
it over heated and stopped so the next day i tried starting it and it did so i imediatly took the radiator cap off to check the fluid and it stated squirting out so i turned the engine off and now it wont start i replaced the water pump recently but not timing belt and i noticed when the engine stopped water was coming out my wy water pump
Experienced mechanics share their insights in answering this question :
It sounds like you may have a blown head gasket. A blown head gasket may cause a number of different symptoms. A head gasket that fails between cylinders will generally cause a misfire and perhaps few other symptoms. A failure between cylinders will cause compression leaks from one cylinder into another. Low compression results in a rough idling engine. Damage of this type may not cause overheating, coolant in the oil or any other outward sign. Many people overlook this as the cause of engine misfires, because the blown head gasket does not also give the other more common symptoms. When the head gasket fails between a cylinder and the coolant port, coolant may leak into the cylinder. This often results in misfires on startup, especially after the engine is run, turned off and restarted. This type of failure may not show with a compression test. Pressuring the cooling system and then starting the engine, may make the misfire more noticeable. I would recommend having an expert from YourMechanic come to your location to properly diagnose the symptoms you describe.
How to Identify and Fix Common car Problems ?
Our sources include academic articles, blog posts, and personal essays from experienced mechanics :
Why won`t my car start but I have power? If you attempt to start up your car but the engine won`t turn over and the dashboard lights up, then you most likely have an issue with your battery. You could have a damaged or corroded battery terminal, which is stopping the engine from starting up when you fully turn the key.
Connected to the battery is the alternator, which works to generate power for your vehicle`s electrical components. When you have a brand-new battery but still can`t start the car, the alternator might be the issue. Cold and damp climates may increase wear on an alternator, causing it to fail.
Check the battery if there is a slow crank and a clicking sound, and the car engine won`t start. However, if the check engine light illuminates, the issue could be the engine or fuel pump. If your vehicle doesn`t start, call AAA, roadside service, or another towing company to take your car to get it repaired.
When you attempt to start the vehicle, is there a clicking sound, but it won`t turn over? That may be a good sign. If a jump gets the car running, but won`t turn over again once it`s shut off, a dead battery is likely the cause.
It might be a battery or alternator problem.
If the source of the clicking is electrical, the starter (a small motor energized by the battery that gets the engine running) doesn`t have enough juice to stay powered. So instead, it rapidly turns on and off and produces a clicking noise!
How Much a Starter Replacement Costs. The cost of rebuild parts for a starter can range from as little as $50 to as much as $350. A brand-new starter can range from $80 to over $350. For a qualified mechanic to replace or rebuild your starter, you can expect to pay between $150 and over $1,100.
In general, your car will usually need a new battery after three to four years. Replacing your car battery is another part of routine maintenance. Getting your battery checked and inspected is standard for your service visits after three years, even if you haven`t needed it replaced yet.
Average car starter lifespan
A car starter can give you around 80,000 starts before you should expect it to struggle, regardless of the mileage you drive. This is around 150,000 miles for some cars, while some starters can last the vehicle`s life.
Bad Sensors
One common culprit for this problem is the crankshaft position sensor, which measures the position and speed of the crankshaft. The computer uses the information from this sensor to know when to fire the spark plugs. If the sensor isn`t working, the spark plugs won`t fire, keeping the engine from starting.
An effective method to determine whether it`s your battery or alternator that`s gone bad is to connect jumper cables from a running vehicle`s battery to yours. After a few moments, try starting your vehicle. Once it`s started, remove the jumper cables — if your engine stalls, your alternator has probably gone bad.
Relevant Questions and Answers :
the most relevant questions and answers related to your specific issue
My car will not start Intermittently. I purchased a new battery 2 weeks ago and yesterday the car wouldn’t start. Got a jump and
ANSWER : The issue you are having is probably due to an intermittent fault in the starter motor itself or a deficiency in the starter electrical circuit, for example a large voltage drop due to a poor ground or a high resistance connection. These issues can be readily diagnosed and resolved on a mobile basis if you request a hard starting diagnostic. If you request that diagnostic, the responding certified mechanic will get this resolved for you promptly. Based on Toyota’s Factory Service Manual, the battery should not be disconnected if the vehicle engine is running. The battery acts as a large resistive voltage sink and consequently taking the battery out of the circuit, while the alternator is still running, can create a voltage spike on the car’s electrical system which is not good for voltage sensitive components such as the engine computer. If you have further questions or concerns, do not hesitate to re-contact YourMechanic as we are always here to help you.
Fuel pump engages. Batery good, alternator good volts, jump start helps when wont start. Temp does not matter. Intermittent?
ANSWER : Hello. Thank you for writing in. There are several reasons your vehicle may only start when jump starting. The first and most common is a build up of resistance that is causing you to need a boost of voltage to get the engine started. This may be due to poor battery cables, a bad ground connection, a poor starter solenoid, and a couple of other issues. The first thing you want to do is perform a visual inspection of the starting system. Make sure there is no corrosion build up in the battery cables. You can also check the resistance across these wires and make sure you have a solid connection between components. You then want to make sure the starter solenoid is doing its job. It is responsible for taking the small amount of electricity sent by the ignition and turning it into a huge electrical charge that is strong enough to push over the engine with the help of some gear ratios in its favor. Do some more testing, and stick to the basics before assuming its something seriously complicated.
car hesitates when trying to start the car ,but when started then i shut car off and start again it will start right up
ANSWER : Hi there:
Sometimes when you have problems starting an engine initially it is caused by a restriction in fuel flow; caused either by clogged fuel injectors or the throttle body that needs to be cleaned. Once the fuel starts to flow and engine warms up, it’s much easier to start. However, it could also be an air filter, EGR valve or other components that causes this issue as well, which is why it’s best to have a professional mobile mechanic complete a car is hard to start inspection so they can pinpoint the source of this issue.
Map sensor car won’t start up good ?
ANSWER : Your MAP sensor is an important input for your computer. It helps determine the load on the engine to calculate the correct amount of fuel to inject. It sometimes takes a few seconds for the vehicle to realize that the sensor is not producing a good signal.
At that point, it will use other methods to determine the fuel rate, such as pre-programmed fuel maps, throttle position, etc. I would suggest replacing the MAP sensor and retesting. If you would like to have it checked first, a certified technician from YourMechanic will be able to scan your vehicle and test components to determine the root cause of your starting issue before making a repair.
Charging warning light comes on when i turn the key and try to start the car and the car want start but when someone tried to give
ANSWER : Hi there:
If you recently replaced your battery, the issue may be caused by a malfunctioning alternator or other electrical component that comprises the charging system on your Nissan Sentra. The best way to find out which item specifically is faulty, is to have a professional mobile mechanic complete a car is hard to start inspection. This will allow the mechanic to determine the precise source of what’s going on with your Sentra and recommend or complete the right repairs.
My car stutter starts, but only after driving it for a few minutes.
ANSWER : Hey there. This may also be caused by what is called the fuel pressure regulator. This is a unit that helps to maintain the fuel pressure at the proper level. When this is not working properly, the fuel pump may be pumping properly, but the fuel may not arrive at the fuel injectors at the proper psi. When this happens, this can cause a lean fuel condition which may cause the car to hesitate, misfire, or stall. If you would like to have an expert pinpoint the issue, a certified professional from YourMechanic can come to your car’s location to inspect the hard start problem and confirm which repairs are needed.
Why does my car start one day and the next day it wont start? The car will crank but wont turn over
ANSWER : Hello, thank you for writing in. With intermittent symptoms, diagnosis can take longer but is typically the same as diagnosing any other starting problem. The main issue is that you can only perform the testing needed when the issue is occurring. If the vehicle starts and works normally, all of the components are likely going to pass their tests. There are several components that will work intermittently. They include the fuel pump, charging system, a number of sensors, and any electrical connection that is loose. When the vehicle is not starting, test for fuel pressure, spark, and the electrical connection on any of the sensors that effects starting (air intake, camshaft/crankshaft position sensors). For more diagnostic help, contact our service department to schedule an appointment.
EPC light on and started losing power as well as taking longer to start the car. now the car wont start
ANSWER : Hi There,
The EPC light is typically related to the ECM (computer) not receiving the proper signal from the crankshaft position sensor. A crankshaft position sensor is an electronic device used to monitor the position or rotational speed of the crankshaft. This information is used by engine management systems to control the fuel injection or the ignition system timing and other engine parameters. When this is faulty or not working properly, this will cause problems with the ignition system and generating spark transmission to the spark plugs resulting in starting problems and other performance issues causing misfires. I would recommend having an expert from YourMechanic come to your location to diagnose and inspect your vehicle.
