Car stalled out while driving, and can’t get it to turn over – 1998 Ford Escort

ANSWER : Hello there. The charging system on the car may not be charging the battery as you drive and the systems that keep the engine running are priority so the engine will stay running until the voltage drops below about 9 volts but the lighting and some other accessories may cut off above this voltage first. You should have the charging system tested to see if the alternator needs to be replaced.

ANSWER : Hi there. Check the alternator and make sure that the wiring it connected tight. Check the battery cables and make sure that they are tight and clean. Look for any loose ground wires to the chassis on the vehicle. If everything checks out to be working correctly, then the PCM may need to be replaced as it may have a battery disconnect condition. If you need further assistance with multiple functions shutting off, then seek out a professional, such as one from Your Mechanic, to help you.

ANSWER : Hello, from what you’ve described it sounds like you are having several different issues. The starter should have nothing to do with it stalling, but it will have something to do with the car restarting if it doesn’t turn the engine well. The stalling can be from the distributor or possibly a computer sensor.

The scenario where you hit a car from behind may be from another problem, alongside with the idling of the engine. Without knowing the model and engine size of your car I can only say so much. I would suggest having a mechanic do a thorough check of the entire car to check the engine, brakes, and computer systems to see if the problems can be identified and repaired, or at the very least quoted.

ANSWER : Hi there. This type of electrical glitch can be very difficult to pinpoint or diagnose without a physical inspection. However, in general, the most common causes of this issue is an exposed electrical wire within the ignition system. It is best to have a professional mechanic complete an electrical problems inspection first in order to correctly diagnose and resolve this issue.

ANSWER : Your probably correct, it sounds as though your battery is done. But it also sounds like you have charging system issues. I’m not sure that fixing your battery and charging system will solve the problem with the car shutting off, but it’s possible that it will and it’s a darned good place to start. By contacting Your Mechanic, you can have a technician come to your home or office to check out your car and help you figure out what to do next.

ANSWER : Hello – your Fiesta has a transmission which Ford calls the DPS6 (or DCT – Dual-clutch transaxle). This 6-speed transmission has 2 clutches, controlled by a computer, which allows selection of multiple gears at once (say 1st and 2nd), and the clutches manage the gear change be releasing 1st gear with one clutch, and engaging 2nd gear with the second clutch. This transaxle has had LOTS of problems with "shuddering" between gears, lack of smooth take-off, and the list of Customer Satisfaction and Technical Service Bulletins for this and other models using this transaxle is rather long. Ford has been replacing the clutches, and updating the software on a regular basis, and there are several warranty extensions up to 10 years/150K miles on this transmission. But – don’t delay, get your car to a Ford dealer to have this corrected ASAP.

ANSWER : The initial failure was likely caused by a sudden fuel system (e.g., failed fuel pump) or electrical (including ignition) faiure. Prior to performing diagnostics be sure you have a fully charged battery that passes a load test. Then, confirm that the engine immobilizer system (security system) is not activated thus preventing the car from starting. If the starter motor is not functioning, check for power to the starter motor when the key is held in the "start" position. If there a large voltage drop at the starter motor or no power at all, you may have a faulty ignition switch but you do have to check out the entire starter circuit, which includes grounds, wiring (some of which is very heavy cabling), fuses, relays, the ignition switch and terminations. On the other hand, if the starter motor is getting power but the starter doesn’t work, then the starter is condemned and replaced. If you desire that a certified mechanic resolve this, please simply request a no start diagnostic and the responding certified mechanic will get the problem diagnosed and repaired for you. Please let us know if you have further concerns or questions as we are always here to help you.

ANSWER : Hi there. The symptoms you’re describing with your boyfriend’s 2002 Grand Cherokee appear to be related to a broken or worn out ignition switch or relay. The ignition switch on the inside of the steering column is attached to multiple electronic connections that send signals to a relay box; which in turn, sends the signal to the individual components. The issue could be related to the ignition switch, the relay, or any of the components in between. If you want to have the fault pinpointed in person, I would have this starting issue inspected by a trained professional to ensure that the correct repair is made.