Car shut down while driving, but started right back

ANSWER : Hi there. Check the alternator and make sure that the wiring it connected tight. Check the battery cables and make sure that they are tight and clean. Look for any loose ground wires to the chassis on the vehicle. If everything checks out to be working correctly, then the PCM may need to be replaced as it may have a battery disconnect condition. If you need further assistance with multiple functions shutting off, then seek out a professional, such as one from Your Mechanic, to help you.

ANSWER : Hi there:

Sometimes when you have problems starting an engine initially it is caused by a restriction in fuel flow; caused either by clogged fuel injectors or the throttle body that needs to be cleaned. Once the fuel starts to flow and engine warms up, it’s much easier to start. However, it could also be an air filter, EGR valve or other components that causes this issue as well, which is why it’s best to have a professional mobile mechanic complete a car is hard to start inspection so they can pinpoint the source of this issue.

ANSWER : The issue you are having is probably due to an intermittent fault in the starter motor itself or a deficiency in the starter electrical circuit, for example a large voltage drop due to a poor ground or a high resistance connection. These issues can be readily diagnosed and resolved on a mobile basis if you request a hard starting diagnostic. If you request that diagnostic, the responding certified mechanic will get this resolved for you promptly. Based on Toyota’s Factory Service Manual, the battery should not be disconnected if the vehicle engine is running. The battery acts as a large resistive voltage sink and consequently taking the battery out of the circuit, while the alternator is still running, can create a voltage spike on the car’s electrical system which is not good for voltage sensitive components such as the engine computer. If you have further questions or concerns, do not hesitate to re-contact YourMechanic as we are always here to help you.

ANSWER : Hello – your diagnostic intuition is good, this problem is most likely a fuel supply problem! A failing fuel pump, clogged fuel filter, or fuel pump with burned contacts could all cause the "loss of power" behavior you experience. If you do not hear the fuel pump running, or it sounds loud and harsh, that would further suggest a pump failure if the fuse is good. I would recommend an inspection of the fuel supply system to address the loss of power and stalling. A mobile, professional mechanic, such as one from YourMechanic, will come to your location, confirm this diagnosis, give you an accurate assessment of damage and cost estimate for repairs

ANSWER : Hey there. This may also be caused by what is called the fuel pressure regulator. This is a unit that helps to maintain the fuel pressure at the proper level. When this is not working properly, the fuel pump may be pumping properly, but the fuel may not arrive at the fuel injectors at the proper psi. When this happens, this can cause a lean fuel condition which may cause the car to hesitate, misfire, or stall. If you would like to have an expert pinpoint the issue, a certified professional from YourMechanic can come to your car’s location to inspect the hard start problem and confirm which repairs are needed.

ANSWER : Hi there. What had happened is the wrong key set the security to the vehicle. This is to prevent the vehicle from starting with the wrong keys. Try removing the battery cables (+) and (-) for 13 minutes. During that time, put the original key in the ignition and turn it on. Activate everything in the car even though there is no power. Then remove the key and hook up the battery cables. The computer should have reset and reset the security. If the security is still being tripped, then I recommend seeking out a professional, such as one from Your Mechanic, to help you

ANSWER : Hello, thank you for writing in. It is difficult to determine the issue without some more information. To start, when the check engine light illuminates, you want to scan the vehicle for diagnostic codes. These are what set the check engine light off, and are meant to tell the driver what the computer has detected is wrong. Codes can be pulled at most automotive parts stores, and by most technicians. Once you have that information you can focus in on one component or system. If the engine is truly overheating, then you want to start by checking your coolant and fluid levels. For more help with diagnosing and resolving the issue, contact our service department to schedule an appointment.

ANSWER : Hi There,
It sounds like you are describing the symptoms of a failing throttle position sensor. The throttle position sensor monitors the throttle position of the throttle plate inside the throttle body in relation to your foot position on the gas pedal. Based upon the inputs from the sensor reading your foot’s position on the pedal, the ECU then makes the direction to supply more or less fuel to the motor. When this sensor is not working properly, this can cause intermittent responses when pressing the gas pedal. I would suggest having a professional from Your Mechanic come to you home to diagnose and inspect your vehicle.